ECopy 3323B001 - imageFORMULA ScanFront 220e Installation And Setup Manual - To Set Up The Device:
26
|
Quick Start: Installing and setting up ShareScan
Setting up the Canon ScanFront device
Setting up this device involves specifying a password for the device and then associating the
device with the PC running the ShareScan Services Manager, which is called the ShareScan Host.
To set up the device:
1
Power on the device.
The calibration screen appears.
2
Follow the on-screen instructions to calibrate the device screen.
When calibration is complete, the
Password
page appears.
3
Specify a password for the device and then select
Next
.
A password is not required. If you do not want to set a password, leave the password field
empty and then select
Next
.
The
Network
page appears. This page enables you to connect the device to a network.
4
Specify the device’s network settings and then select
Save
.
5
When prompted, restart the device.
6
Enter the password and then select
Next
.
The
ShareScan Address
page appears.
7
Enter the IP address of the PC where you installed ShareScan. (Do not enter the IP address
of the ScanFront device.)
You can find the IP address of the Services Manager PC in the Administration console,
immediately under the ShareScan node. For example, the IP address in the following
sample screen is “10.10.14.217”.
8
Click
Connect
.
The ShareScan Client application appears, indicating that you can now add the device to
the ShareScan Services Manager (see page 29).
Note:
You must specify a valid device name, IP address (static address only), subnet mask, and
default gateway. If you do not have this information, see your network administrator.