ECopy ScanStand Assembly Instructions Manual - page 11
eCopy ScanStand Assembly Instructions
9
Fastener Kit #4: P/N 16-5001-D
Components shown full size to help identification
4.1
Rotate bracket 180 degrees so eCopy logo faces
the arm segments.
Caution! Placing the arm on the post without first
rotating the bracket may cause tipping.
4.2
Insert 30 mm (1-1/8 inch) hex bolts into arm
bracket from rear (opposite the side with the
eCopy logo). Bolt heads should be on flat side of
bracket.
4.3
Place a washer and round head nut on each
bolt. Turn only 2-3 times, leaving bolt heads
extended at least 16 mm (5/8 inch) from arm
bracket.
4.4
With arm folded, align bolts heads as shown
below and slide bolts into T-slot on flat side of
post.
Note bolt head alignment and required gap
4.5
Tighten the nuts securely using 13 mm wrench.
Do not attempt to loosen or tighten the
Allen screws on the arm joints. These are
set at the factory and do not require
adjustment.
Step 4: Arm assembly attachment