ECopy ScanStand Assembly Instructions Manual - page 9
eCopy ScanStand Assembly Instructions
7
Fastener Kit #2: P/N 16-5001-B
Components shown full size to help identification
2.1
Examine rear of copier and determine which of
the vertical struts to use for the L bracket.
Position bracket to avoid contact with vents or
cable connectors.
2.2
Put a washer on each 45 mm (1-3/4 inch) hex
bolt.
2.3
From back of frame, insert bolts through top
and bottom holes in selected strut.
2.4
Place L-bracket on bolts and attach loosely using
hex nuts.
2.5
Slide bracket to lowest position. You will re-
position and tighten the L-bracket later.
Before you attach the L-bracket,
determine which vertical strut you will
use for the arm support post and attach
the L-bracket to an unused strut.
Left configuration with optional L-bracket position
Vertical struts
Step 2: L-bracket attachment