EcoStage V-101 User Manual - page 3
4
Safety information
important
Every person involved with the installation , operation and maintenance of this
device has to be qualified and follow the instructions of this manual .
Manufacturer will not with responsibility for those operation not according to this
Instruction
Verify that the voltage matches the rated voltage.
When the voltage is 110V , Do not connect more than 10 lightings in total to
AC mains power in one interconnected daisy chain
When the voltage is 220V , Do not connect more than 20 lightings in total to
AC mains power in one interconnected daisy chain
Before using the fixture, check that all power distribution equipment and
cables are in perfect condition and rated for the current requirements of all
connected devices.
Always ground (earth) the fixture electrically .
Avoiding hit the Light when you are move or install the light .
The minimum distance between light-output and the illuminated surface
must be more than 0.5 meters. Keep all combustible materials (for example
fabric, wood, paper) at least 0.2 meters away from the fixture .
Do not expose the fixture to rain or moisture.
Avoid looking directly into the light source (especially those who suffer from
epileptic fits)
Maximum ambient temperature (Ta) is 40°C. Do not operate fixture at
temperatures higher than this .
The Maximum surface temperature is 50°C
When suspending the fixture above ground level, verify that the structure can
hold at least 10 times the weight of all installed devices.
Verify that all external covers and rigging hardware are securely fastened and
use an approved means of secondary attachment such as a safety cable.
5
Power connection
Installing a Neutrik connector on a power cable
Put bushing and chuck onto thecable.
Prepare cable as shown above. The power cable must is a three-conductor
2.5mm
2
cable.
Insert the wire into the terminals and fasten the clamping device by a flat
screw driver.
Push insert and chuck into housing (pay attention to the guiding keyway.)
Fasten bushing.
the color-coding schemes and some possible pin identification schemes; if
pins are not clearly identified , or if you have any doubts about proper
installation , consult a qualified electrician
Wire color
Conductor
Symbol
Brown
Live
L
Blue
Neutral
N
Yellow/green
ground