EcoStage V-101 User Manual - page 4
6
Handling
Relaying power to other devices
The lightings can be linked in a chain by power cables which installed a blue and
a light-gray connectors on the two ends. the light-gray connector connects to the
power out socket of the first lighting , and the blue connector connects to the
power in socket of the subsequent lighting, and so on.
The power cable must is a three-conductor 2.5mm
2
cable.
When the voltage is 110V , Do not connect more than 10 lightings in total to AC
7
mains power in one interconnected daisy chain.
When the voltage is 220V , Do not connect more than 20 lightings in total to AC
mains power in one interconnected daisy chain .
Physical installation
This lighting can be placed on a horizontal surface such as a stage or clamped to a
truss or similar rigging structure in any orientation using a rigging clamp.
When suspending the fixture above ground level, verify that the structure can hold
at least 10 times the weight of all installed devices.
Verify that all external covers and rigging hardware are securely fastened and use
an approved means of secondary attachment such as a safety cable.
How to install a clamp to the lighting:
1.
Choose a clamp with M10 bolt , the bolt is 30~40cm.
2.
Screw a M10 nut to the clamp bolt , use a spanner to tighten it.
3.
Screw the clamp into the base of the fixture as below picture.using a spanner
to make the clamp,nut,sping washer,flat washer tightly together .