EcoStage V-101 User Manual - page 9
16
①SET menu
SET Menu:
├Reset Machine
│ ├Reset:ON
│ └Reset:OFF
├Load Parameter
│ ├Load ON
│ └Load OFF
├Master / Alone
│ ├Master Mode
│ └Alone Mode
├Auto / Sound
│ ├Auto Mode
│ └Sound Mode
├MIC Sense:00~99%
├TC Switch
│ ├TC Switch Mask
│ │ ├Switch ON
│ │ └Switch OFF
│ └TC Switch Temp
│
├TC Temp Cap
│
└TC Temp Set
├Scan Setting
│ ├Reverse Pan
│ │ ├Reverse Pan :ON
│ │ └Reverse Pan :OFF
│ ├Reverse Tilt
│ │ ├Reverse Tilt:ON
;Reset the machine
;Do not reset the machine(default)
;Restore factory settings
;Do not restor factory settiings(default)
;(default)
;(default:20)
;Temperature control,it will reduce the output
afeter over temperature
;Enable the switch(default)
;Disable the switch
(password protected)
;Capture the current temperature
;Set the value of the TC switch
;(default)
17
│ │ └Reverse Tilt:OFF
│ ├Pan Degree
│ │ ├Pan Degree:630
│ │ └Pan Degree:540
│ ├Scan BlackOut
│ │ ├ScanBlackOut:ON
│ │ └ScanBlackOut:OFF
│ └Feed Back
│
├Feed Back:ON
│
└Feed Back:OFF
├Dimmer Curve
│ ├Square Law
│ ├Inv Square Law
│ └S-Vurve
├Dimmer Speed
│ ├Dimmer: Smooth
│ └Dimmer: Fast
├Dmx Reset
│ ├Enabled
│ ├Disabled
├Fan
│ ├Regulated
│ └Full
└Information
├Time:tt/mm/ss
├Date:mm/dd/yy
└Use Time :hour: minute
;(default)
;Set the max angle rage of the Pan
;(default)
;Black out while the motor runs
;(default)
;Enable pan/tilt position feedback;(default)
;Disable the feedback
;(default)
;(default)
;Enable reset via DMX;(default)
;Disable reset via DMX
;Fan speed
;Thermostatically regulated(default)
;Max. cooling fan speed