ECOVACS DEEBOT D77 Instruction Manual - page 11
Edge Cleaning Mode:
This mode is good for cleaning the edges of a room.
Spot Cleaning Mode:
This mode is applicable for an area of highly concentrated dirt or dust.
In Edge Cleaning Mode, the DEEBOT will detect a border - such as a wall - and it
will continue along that path until it meets an obstacle at which point it will alter
its direction.
In the Spot Cleaning Mode the robot operates in a “zigzag” pattern from left to
right, focusing on a specific area to clean. After the cleaning, the robot will return
to its starting point and emit a beep.
3.4 Programming the Robot
DEEBOT can be programmed to automatically clean once per day, at a specific time, even if nobody is at home.
Schedule the Cleaning Time
1. With the power ON, press and hold until the symbol on the LCD illuminates and the number with time
setting flashes.
2. Enter the time you would like the robot to clean. Press or key to adjust the “hour,” press to confirm the
hour, and “minute” number will blink. Use the same method to adjust “minute” and press to confirm.
Scheduled cleaning time is complete.
Example: If you would like the scheduled cleaning time to be set for 12:08 p.m.,
the display screen should read:
Set / Confirm the Current Time of Day
1. After scheduling the cleaning time, the icon disappears and the “hour” number blinks, indicating you can set or
confirm the current time of day.
2. To set the current time of day, adjust the hours and minutes using the same method as schedule the cleaning
time above, or confirm the current time by pressing the (insert picture) key twice.
Set Cleaning Frequency / Cancel Scheduled Cleaning Time
1. Set the cleaning frequency by pressing the clock key until the desired icon appears.
Clean once at scheduled time.
Clean daily at scheduled time.
Cancel cleaning at scheduled time. Robot only operates manually with this setting.
Operating and Programming
EN