EcoWater EWS-EU500/230 Owner's Manual - page 4
ELECTRONICS (MODEL EWS-EU800/230)
continued from page 3
Check Delay Time Status:
Press the ‘DELAY’ button once. The Delay Start
Time appears in the display window with ‘DELAY’
in the display. After 3 seconds the current time
reappears.
Switching the Purifier On/Off:
To turn the Purifier on or off, press the ‘ON/OFF’
button. When turning the Purifier on, the ‘ON’
symbol appears in the display window and the
Red Indicator Light appears. After turning the
Purifier off, the Red Indicator Light turns off.
Carafe Indicator:
If the carafe is not in the correct position, the Red
Indicator Light blinks and ‘CARAFE’ blinks in the
display window for 90 seconds. Then the unit will
shut off. If the carafe is removed from the base
unit during operation, ‘CARAFE’ indicator will
appear in the display for 90 seconds. At 90
seconds the unit will shut off. To restart, place
the carafe in position and press ‘START’.
Kettle Indicator:
If the kettle is removed during a cycle, the unit will
shut off immediately. The red indicator light will
blink continuously if kettle is not correctly
positioned.
The Carbon Filter Indicator shows four status
bars to indicate filter life. Four bars indicate a
new filter and zero bars indicate the filter needs to
be changed. In addition to the bars a ‘FILTER’
indicator (not the bars) will flash in the display
when the filter needs to be changed. To reset the
Filter Status Bars to new filter status, press and
hold the delay button for 7 seconds.
BEFORE USING WATER FROM YOUR WATER PURIFER FOR THE FIRST TIME
Although care is taken so your Purifier, kettle and
carafe are clean, some harmless matter may
remain from manufacturing, packaging, or
shipping. This could leave an unwanted taste or
odour in the purified water the first time you use it.
To remove any taste or odour causing matter, do
the following:
1. Set the Purifier on your counter or tabletop.
2. Remove kettle from its receptacle.
3. Remove kettle cover twisting counter
clockwise, then lift.
4. Wash inside of kettle with soap and water
then rinse and fill to the ‘MAX’ line. Ensure
the electrical contacts remain dry at all times*.
5. Replace the cover onto the kettle. Twist
clockwise to lock. Plug the kettle into the
base receptacle.
6. Wash carafe and lid with soap and water and
then rinse.
7. The carbon filter is packed in a separate
plastic bag. The filter is only used if you
intend to drink the water and must not be
used for water used in an autoclave, chairside
water bottle, ultrasonic bath and for rinsing.
Remove the cover of the carbon filter housing
located inside the carafe lid. Remove carbon
filter from bag and place into housing.
Replace cover on housing, and replace lid on
carafe (see view on page 6)
8. IMPORTANT: Before using the carbon filter
rinse the filter under purified water for 30
seconds, so that it is wet on all surfaces. If
the filter ever dries out as result of not using
the purifier, remove it and rinse it to re-wet it
down.
9. Place the carafe on the base unit, and plug
the power cord into a wall outlet.
10. For model EWS-EU500/230 press the
‘RESET’ button to turn the Purifier on. Run
one batch of water to the carafe. Unplug the
kettle from the base unit.
11.
For model EWS-EU800/230, press the
‘START’ button to turn the Purifier on. Run on
batch of water to the carafe. Press ‘STOP’
button to stop purifier
.
*You may want to purchase a trip switch to help
protect the unit. See notes on back page.
Continued, page 5