EcoWater EWS-EU500/230 Owner's Manual - page 5
BEFORE USING WATER FROM YOUR WATER PURIFIER FOR THE FIRST TIME
continued from page 4
12. Steam will continue to pass through for a few
minutes. After unit cools, rinse out kettle.
13. Shake the carafe, then discard the first batch
of water which may have some harmless
carbon particles in it from the filter.
MAKING PURIFIED WATER
1. Set the Purifier on your countertop or table.
2. Unplug the kettle from the base (Fig. 1) Twist
the cover counter-clockwise to remove, and
set aside.
3. Rinse and fill the kettle with tap water up to
the MAX fill line. Do not put the kettle under a
running tap as the electrical contacts must
remain dry.
NOTE: You can purify less than the full amount.
Use this chart as a guide. DO NOT fill the kettle
over the MAX fill line because the carafe will
overflow.
WHEN YOU FILL
WITH TAP WATER TO MAX
THE CYCLE TAKES
ABOUT
Model EWS-EU500/230 (3 litres)
Cold water tap 5 hours
Hot water tap 4 hours
Model EWS-EU800/230 (3.8 litres)
Cold water tap 4 hours
Hot water tap 3 hours
4. Replace the cover on the kettle. Twist cover
clockwise to lock. Plug the kettle into the
base unit. Carry carefully and keep level to
prevent splashing.
5. Set the carafe into place on base unit.
6. Plug the power cord into any 230 volt outlet.
7. Press the reset or start button. The red
indicator light will illuminate.
When the cycle is over the Purifier turns off
automatically. AFTER THE FAN MOTOR GOES
OFF, WAIT AT LEAST 30 MINUTES BEFORE
REMOVING THE COVER.
WARNING: NEVER REMOVE THE COVER
WHILE THE FAN MOTOR IS RUNNING, OR
FOR 30 MINUTES AFTER IT STOPS. YOU
COULD GET SEVERE BURNS FROM THE
BOILING WATER OR STEAM.
8. To pour water from carafe, open spout by
pulling on centre strip in direction of the arrow
indicator near thumb position.
9. Store the carafe filled with product water in
the refrigerator until you need it.
10. After the Purifier has cooled (wait for 30
minutes after the fan motor stops running)
remove the kettle to clean.
CARE AND CLEANING OF YOUR WATER PURIFIER
KETTLE
After each use, rinse the inside with lukewarm tap
water and remove any residue. Clean by wiping
out the inside of the kettle with a damp cloth or
plastic scouring sponge and rinse. If a deposit
starts to form at the bottom, use Water Purifier
cleaner (see page 7). Residue build up on the
bottom of the kettle will prevent the system from
purifying a complete batch of water. Remove the
kettle from base unit. Fill kettle with hot water
and follow the instructions on the cleaner bottle.
Rub with a soft scouring pad and rinse
thoroughly.
CAUTION: DO NOT IMMERSE THE PURFIER
OR KETTLE IN WATER.
CARAFE
Clean with mild dish detergent and soft cloth.
Rinse thoroughly with water.
CLEANING EXTERIOR SURFACES
To keep your Purifier looking new, you should
periodically clean the exterior plastic surfaces
with a soft, damp cloth. DO NOT use any caustic
cleaning solutions, scouring pads or powder
because they will damage the plastic finish.
NOTICE
THERE ARE NO USER SERVICABLE PARTS
INSIDE THE UNIT
CHANGING THE CARBON FILTER
IMPORTANT: The purifier uses a carbon filter in
the carafe cover to remove traces of odours
before the purified water is collected in the carafe.
The filters last about 2-3 months. A return of
unwanted odour means the filter should be
replaced. Order replacement carbon filter from
the outlet where you purchased your purifier (see
page 7).
continued, page 6.
5