EcoWater EWS-EU500/230 Owner's Manual - page 8
IMPORTANT NOTICE
PLEASE READ BEFORE USING YOUR PURIFIER
ELECTRICAL CONTACTS MUST REMAIN DRY AT ALL TIMES.
IT IS STRONGLY RECOMMENDED THAT THE KETTLE IS NEVER
PLACED DIRECTLY UNDER FLOWING WATER. FILL USING JUG OR
SIMILAR CONTAINER. (DO NOT USE THE CARAFE AS THIS WILL
CAUSE CONTAMINATION.)
THE KETTLE MUST REGULARLY BE CLEANED USING ECOWATER
PURIFIER CLEANER (SEE PAGE 7) TO PREVENT LIMSECALE BUILD
UP. FAILURE TO COMPLY WILL INVALIDATE THE WARRANTY.
WHEN USING THIS DEVICE IN A DENTAL SURGERY, VETERNINARY
SURGERY, DOCTORS SURGERY, CHIROPODY SURGERY,
LABORATORY, TATTO STUDIO ETC AND THE WATER IS TO BE USED
IN AN AUTOCLAVE, CHAIRSIDE WATER BOTTLE, ULTRASONIC BATH
AND FOR RINSING, THEN THE CARBON FILTER MUST NOT BE
USED AND SHOULD BE DISCARDED BEFORE FIRST USING THE
UNIT.
DUE TO THE NATURE OF THE PURIFIER AND ITS USE, IT IS
POSSIBLE WATER CONTAMINATION OF THE KETTLE PLUG CAN
OCCUR, THUS CAUSING ELECTRICAL PROBLEMS AND POSSIBLE
DAMAGE. CARE SHOULD ALWAYS BE TAKEN WHEN USING ANY
ELECTRICAL DEVICE IN THE VICINITY OF WATER.
AS A PRECAUTION WE RECOMMEND THE USE OF AN RCD (30MA)
TRIP SWITCH BETWEEN THE POWER CORD AND WALL SOCKET. IF
THE PURIFIER CUTS OUT THE KETTLE PLUG HAS BECOME WET
INTERNALLY AND WILL NEED TIME TO DRY OUT.
HARD WATER AREAS
It may be noticed, after even a short period of time that scale is building up on the
inside of the lid and around the rubber seal of the kettle. This means the kettle must
be de-scaled using distiller cleaner (see page 7). Scale accumulating within the
silicone tube of the kettle lid will cause it to become brittle and disintegrate over a
period of time.
When the water you are distilling is very hard, the water may ‘foam’ when it is boiling.
In order to ensure the water in the carafe does not become contaminated it is
recommended to reduce the amount of water used in the kettle so the foaming does
not reach the yellow spigot in the lid of the kettle.
Further advice is available on 01494 484 000.
www.ecowater.co.uk
info@ecowater.co.uk