Ectaco SpeechGuard GL-4 User Manual - Recharge The Battery
ECTACO SpeechGuard™ GI-4
User Manual
19
7. Tap Organize. You will see the Organize MY SPEECHGUARD
screen.
8. Tap Edit. The EDITOR WIZARD will open.
9. Use the EDITOR WIZARD to edit your phrase. For more
information, please read steps 6 – 12 described in the Create a
New Phrase chapter on page 17.
Recharge the Battery
ECTACO SpeechGuard™ GI-4 works up to 1 week without
recharging (in sleep mode) or up to 8 hours of active use. If the
battery power runs too low, a warning message will be displayed.
The following section shows how to recharge the battery.
1. Make sure the battery is inserted in the battery compartment.
♦ Note: Only special Li-Polymer rechargeable battery may be
used with your ECTACO SpeechGuard™ GI-4.
2. Unfix the rubber strip on the right-hand side of the device to
access the AC/DC adapter jack.
3. Connect the AC/DC adapter to your device. The red LED signal
indicates that the battery is recharging and the green one indicates
that the battery is charged.
♦ Note: The use of an inappropriate external power supply may
cause failure of the device and void the warranty. Only special
adapter may be used with ECTACO SpeechGuard™ GI-4.
Check the Battery Life
You can instantly access the battery life indicator at any time to
check if your battery has enough energy.
1. Tap
or
to go to the Main Menu. At the bottom of the
screen, you will see the battery life indicator. A dark indicator
means that the battery is fully charged, and an empty
indicator
shows that it is necessary to recharge the battery
as soon as possible.
2. Tap the battery life indicator to change the battery life picture to
percentage value or a chart.