Ectaco SpeechGuard GL-4 User Manual - Remove Mmc
ECTACO SpeechGuard™ GI-4
User Manual
24
4. Insert the battery into the compartment and screw two screws
back.
Remove MMC
You may need to remove the MMC, for example, to replace it with
a new one containing new linguistic and voice data.
1. Turn the device off by using the On/Off button.
2. Open the battery compartment and remove the battery.
3. Remove the MMC from the slot.
Reset the Device
If you want to restore the default settings for your device or, in the
rare event of a program failure, to recover, you will need to
perform a reset procedure. This can be done in one of the
following ways.
Reset by Using the Reset Button
1. Unfix the rubber strip on the right-hand side of the device (see
General View on page 4).
2. Unscrew the removable cap of the stylus – it will serve you as a
reset pin.
♦ Note: The Reset button can also be accessed with any thin
object such as a paper clip. Never use a needle or a sharp pin
for this purpose since it can damage the device.
3. Press the Reset button. On completion of the reboot, factory-
defined settings will be restored and the General rules screenwill
be displayed.
4. To close the General rules screen, tap
or press the
Recognize button. You will see the Main Menu.
Reset via the Setup Section
1. Go to the Setup section by pressing the Setup button, or just tap
on the word MENU in the upper part of the screen and then select
Settings in the appeared menu.
2. Tap
or press the Left / Right buttons to open the System
Settings screen.