ECX ECX03006 Instruction Manual - page 5

5

EN

RUCKUS

•  Never install damaged batteries.

•  Never install batteries of mixed types or of different ages in 

the transmitter.

•  Always remove exhausted batteries.

•  Always remove batteries before storing the transmitter.

•  Low battery power can result in loss of control of the RC 

vehicle.

TRANSMITTER BATTERY SAFETY PRECAUTIONS

REMOVING THE VEHICLE  BODY

A

B

INSTALLING THE BATTERY IN THE VEHICLE

1. Turn the battery clips (A) clockwise to remove the battery strap (B).

2. Install a fully charged battery.

3. Install the battery strap.

4. Turn the battery clips counterclockwise to secure the battery strap.

If desired, you can put foam blocks (ECX2015) in front of the battery 

so the weight of the battery increases rear traction or in back of the 

battery to increase steering response.

INSTALLING TRANSMITTER  BATTERIES

1. Slide the panel open on the bottom of the transmitter.

2. Obey the battery plus (+) and minus (-) diagram in the 

transmitter to install 4 AA batteries.

3. Slide the panel closed.

We recommend using only alkaline AA batteries in the 

transmitter, however, it is possible to use rechargeable NiMH 

batteries.

CAUTION: If using rechargeable batteries, charge only 

rechargeable batteries. Charging non-rechargeable 

batteries may cause the batteries to burst, resulting in injury to 

persons and/or damage to property.

•   NEVER install damaged batteries, batteries of mixed types 

or batteries of different ages in the transmitter. Remove 

exhausted batteries.

•   NEVER store the transmitter with batteries installed.