Edco TG-10 Operator's Instruction Manual - Maintenance
E-TG10-I-0808
Printed in USA
TVW
©2008
Page 9
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com
Email: sales@edcoinc.com
Maintenance
Disconnect spark plug lead (Figure 10) before pre-
forming any maintenance on this machine! Or on the
electric model, unplug the electric cord at the machine
(instead of at the wall) to assure the machine will
remain un-plugged while you are working on it.
Inspect Every 8 Hours:
•
Inspect the disc mounting screws. (Figure 11) The constant vibration
and heat generated, especially when grinding dry, could cause the
screws to loosen and the disc to become off balance.
Follow the engine manufacturer’s guidelines for regular maintenance.
Lubricate Every 50 Hours:
• Bearings (Figure 12) must be lubricated every 50 hours.
• Belt guard has to be removed to access bearing lubrication
fi tting.
Figure 10
Figure 11
Disc Mount-
ing Screws
Figure 12