Eden RCE10E Installation And Use Manual - Rce10E
TEMPERA
TURE CONTROLLER FOR F
AN COIL
UNIT
RANGE
RCE10E
INST
ALLA
TION
AND
USE GUIDE
2.7.5 Configurable p
arameters
Ta
ble
1
N.o
POSITION "D"
1 Wint. / Sum. setpoint
W/S Setpoint value setting
-5
20/25 (d.z.= 5)
20/24 (d.z. =4)
21/23 (d.z.= 2)
-
20/25 (d.z.= 5)
2 Type of system
Defines the type of system
-4
2 pipes + 1 SOL. V.
4 pipes + 2 SOL. V.
2 pipes with heat only Heat. El. Fan only (2/4 pipes) w/out SOL.V.
2 pipes+1 SOL.V.
3 Fan
Defines if the fan is thermostat-controlled or continuous
-3
Thermostat-controlled
Wint. therm/Sum. cont.
Continuous in W/S
Sum. therm./Wint. cont.
Thermostat-controlled
4 Type of outputs
Defines the actuator control mode
-2
Thermal
On/OFF
PWM
-
Thermal
5 Window contact
Defines if the window contact is active when closed or open
C
Closed=Active
Open=Active
-
-
Closed=Active
6 Aux. output function
Defines the auxiliary output function
F
Heating el.
Humid./Dehumid.
Damper
Grille
Heat. el.
7 Temperature offset
Corrects the temperature value read by the air sensor
T
0
-2
+1
+2
0
8 Set variation limit
Limits the Setpoint variation for the user turning the knob
+2
±5 °C
±2°C
±3°C
±4°C
±5 °C
9 S/W switching
Switching between Cooling and Heating
+3
Manual
H2O sensor/contact M16
From room temp.
-
Manual
10 Water sensor
Fixes the function of the water sensor (AQ)
+4
Fan acknowledgement
Absent
S/W switching
-
Fan acknowledgement
Reset
Resets all parameters to factory values (default)
+5
-
Reset
-
-
-
PARAMETER TO BE SET
DESCRIPTION OF PARAMETERS
POSITION A
SELET.
A
POSITION SPEED 1
POSITION SPEED 3
POSITION SPEED 2
FACTORY
SET POINT
OFF
A
ON
COMFORT
-
+
FILTER
MO D E
C
E
8