Emotiva UMC-200 User Manual - page 17

Page 12

UMC-200

8. Power Switch

Switches the AC main power to the UMC-200 On and Off. When this switch is Off, the 

UMC-200 will not respond to trigger signals or manual controls.

9. Balanced Subwoofer Output

Connect one powered subwoofer (with a balanced input connection) to this output. (This is 

also the place to connect an amplifier with a balanced input that is used to power a passive 

subwoofer.)

10. 7.1 Channel Main Outputs (unbalanced)

Connect these outputs to the inputs on the amplifier that runs your main speakers, and the 

unbalanced input of your powered subwoofer (or subwoofer amplifier).

11. Mix Output (unbalanced)

Provides a stereo (down-mixed) copy of the 7.1 channel output available at the main 

outputs. (This output can be used to provide signal to an analog recorder or other auxiliary 

device.)

12., 13. Zone 2 and Zone 3 Outputs

These outputs provide stereo (unbalanced) outputs for two additional zones (besides the 

main zone). Use these outputs to send independently-controlled music to amplifiers in other 

areas of your home.

14. USB Data Input

This input is used only to update the UMC-200. If an update is offered, instructions will be 

provided to explain how to apply it using this connector.

15. IR Remote Control Input and Output

Connect an external IR remote sensor to this input.  

Connect an external IR “blaster” to this output.

16. Trigger Outputs (2)

These two trigger outputs can be programmed to control other trigger-enabled devices 

(typically they are used to turn on power amps, or amps in different zones, or possibly a 

sub-woofer). Each trigger output can be independently programmed to turn on specific 

equipment when certain zones or inputs are selected. Maximum current draw on each 

Trigger Output should not exceed 100 mA.

17. Standard IEC power inlet

The UMC-200 can be used with either a two-wire or three-wire standard IEC power cable.