Emotiva UMC-200 User Manual - Emoq™ Gen2

Page 16

UMC-200

EmoQ™ Gen2

Automatic Room Correction and Loudspeaker Calibration

EmoQ Gen2 sends a series of test signals through your speakers, measures the 

results with the (included) calibrated microphone, and configures the UMC-200 to make 

your system sound its best. Even though the actual operation of EmoQ Gen2 is very 

sophisticated, it is very simple to use, and will deliver excellent results without manual 

tweaking in most situations. (EmoQ also does allow you to fine tune the settings and 

calibration curves it generates after you run it, and to create your own manual calibration 

settings as well. You should also bear in mind that the choices EmoQ makes may not agree 

with your musical tastes; if so, then you should always go with what you prefer, and adjust 

your EQ settings accordingly.)

First, unpack your calibration microphone, unwind the wire, and plug it into the Microphone 

jack on the front panel of the UMC-200. (The UMC-200 is calibrated for this particular 

microphone, so don’t use a different one.)

Second, place the microphone in your listening location. While EmoQ will do its best to 

optimize the sound for your entire room, the calibration curve and settings it generates will 

still be the most precise at the position where the microphone was positioned when the 

calibration was carried out. The microphone should be placed where your head is normally 

located.

Here are some tips for best results:

•  The test will take several minutes, and some of the test tones are annoying, so you 

might want to take pets or children out of the room (especially if they are noisy).

•  Position the microphone close to where your head or ears normally are (on top of the 

back seat cushion of your favorite chair or couch or, ideally, attached to a stand or 

tripod).

•  The microphone is normally positioned with the point up (and the flat base down).

•  Do not place the microphone in a location where it is blocked from a direct line-of-

sight to any speaker (like on a chair seat). If the microphone cannot “hear” a particular 

speaker, EmoQ will raise the level of that speaker so it presents a balanced sound at 

the position of the microphone, which will probably result in that speaker being too loud 

for everyone else.

•  Try to avoid flat reflective surfaces. If you must place the microphone on a table or other 

reflective surface, place a towel or blanket under it to minimize reflections.

•  Turn off any air conditioners or other gadgets that make noise, and avoid talking or 

making noise during the test. Also turn off or remove from the area any telephones 

that are likely to ring. If you live in a high traffic area, or have noisy neighbors, for best 

results wait for a quiet time of day to run EmoQ. (If anything makes noise during the 

test, it will throw off the results, and you’ll have to run EmoQ over again for best results.)