Empire Comfort Systems VFSE-18-1 Installation Instructions And Owner's Manual - page 33
28092-8-0614
Page 33
VFSV REMOTE CONTROL INSTRUCTIONS
NOTE: This remote is for use on VFSV Models ONLY.
INTRODUCTION
This remote control system was developed to a provide safe, reli-
able, user-friendly remote control system for gas heating appli-
ances. The system can be operated manually from the transmitter.
TRANSMITTER
The transmitter operates on a 12V (A23) battery that is included.
Install the 12V battery supplied with the unit into the battery com-
partment. It is recommended that ALKALINE batteries always be
used for this product.
Be sure the batteries are installed with
the (+) and (-) ends facing the correct direction.
The LED signal light should illuminate when either the
ON/OFF or
HI/LOW button is pressed. If the signal light does not illuminate,
check the position of the transmitter's battery, and if the battery is
fully charged.
KEY SETTINGS
1.
ON/OFF - This turns the appliance On
or Off.
2.
H/L - This controls the height of the
flame. It has four levels: High, Medium
High, Medium Low and Low. The H/L
button will not turn the burner On or
Off.
IMPORTANT: THE REMOTE RECEIVER SHOULD BE POSI-
TIONED WHERE AMBIENT TEMPERATURES DO NOT EX-
CEED 130°F.
RECEIVER
Install the 4 AA-size batteries supplied with the unit. It is recom-
mended that ALKALINE batteries always be used for this product.
Be sure the batteries are installed with the (+) and (-) ends
facing the correct direction.
The remote receiver has a 2-position slide switch for selecting the
mode of operation, which is
OFF/REMOTE
•
REMOTE: The receiver must be in this position if you want
to use the appliance, you must use the transmitter to turn
on the appliance. If the system does not respond to the
transmitter on initial use, check the battery positions in the
remote. If that does not work, see the SECURITY CODE
section.
•
OFF: Will disable the remote receiver.
WIRING INSTRUCTIONS
WARNING: DO NOT CONNECT REMOTE RECEIVER
DIRECTLY TO 110-120VAC POWER. THIS WILL BURN
OUT THE RECEIVER. FOLLOW INSTRUCTIONS FROM
MANUFACTURER OF GAS VALVE FOR CORRECT WIRING
PROCEDURES. IMPROPER INSTALLATION OF ELECTRIC
COMPONENTS CAN CAUSE DAMAGE TO GAS VALVE AND
REMOTE RECEIVER.
CONNECT THE RECEIVER TO THE AF-1031 SERIES GAS
VALVE WITH THE STEP MOTOR
•
Do not install the 4 AA batteries into the receiver until the DC
Step Motor is connected to the receiver. The receiver will cali-
brate the step motor once the batteries are installed.
• Connect the 4 pin female connector from the DC step motor
to the 4-pin male connector on the wire harness.
•
Connect the 4 pin female connector on the wire harness to the
4-pin connector on the back of the receiver.
•
Install the 4 AA batteries in to the receiver.
• After receiver is connected to the DC step motor using the
supplied wire harness, make sure to locate the receiver in an
area that will not exceed the 130°F. This location will always
be towards the front of the firebox.
•
It is suggested that the slide switch be placed in the
OFF position if you will be away from your home for an
extended period of time.