Eyezone p102-8 user manual oct 26, 07 3 4 4 1 2 f 1 3 fcc notices it’s herewith confirmed to comply with the requirements of fcc part 15 rules. Operation is subject to the following two conditions: z this device may not cause harmful interference. Z this device must accept any interference received,...
1. Package contents……………………..…………………….. 1 2. Introduction………………………………….……………... 1 3. Features…………………………………..………………… 1 4. Hardware overview…………………………….…………... 2 5. Remote control…………………………………………….. 3 6. Setting up……………………………………..……..…….. 4 6.1 slide setup……………………………………..…. 4 6.2 music setup…………….…………...
2 multi-language osd:english, french, german, italian, portuguese, spanish, netherlands, japanese and chinese. Supports slide show function: with 14 kinds of transition effects. Supports slide time (interval) mode:interval time with 1, 3, 5, 10, 30, 60 seconds. Supports music slide show:music and pi...
4 press the “setup” button on the remote control to open the “setup menu – main page” shown in the following figure. There are five groups of sub-menu in the setup menu. Use the “▲、▼、 ▲ 、 ▼ ” buttons to select an item or to adjust values, and use the “enter” button to go into the function or to conf...
6 copy files (music, picture and movie) to the memory card first. 7.1 play picture file step 1: press the “slide” button on the remote control from any menu. Step 2: the preview mode will show all the picture files on the memory card. Use the “▲、▼、 ▲ 、 ▼ ” buttons to select the picture file, and pre...
8 7.3 play movie file step 1: press the “movie” button on the remote control from any menu. Step 2: the preview mode will show all the video files on the memory card. Use the “▲、▼、 ▲ 、 ▼ ” buttons to select the movie file, and press the “enter” button to play the movie file. Step 3:press the “next” ...
10 copy the media files that you want play to the memory card. The bar-code and the name of the corresponding file must be the same. For example:bar-code is 1234567, and names the corresponding file “1234567.Xxx”. (xxx is the extension) make sure the “scanner” function is enabled first. “slidesh...
12 code 39 enable code 39 disable 13 codabar enable codabar disable.
14 upc/ean/jan enable upc/ean/jan disable 15 itf 2 of 5 enable itf 2 of 5 disable.
16 chinese post code enable chinese post code disable 17 code 128 disable.
18 code 93 enable code 93 disable 19 ean-128 enable ean-128 disable.
20 code 32 enable (italian pharmacy code) code 32 disable (italian pharmacy code) 21 msi enable msi disable.
22 ean-13 convert to isbn/issn enable ean-13 convert to isbn/issn disable 23 upc/ean add on off add on 5 only.
24 add on 2 only add on 2 or 5 25 ean/upc +add on (none mandatory) ean/upc + add on ( mandatory).
26 force upc-a to ean-13 format enable force upc-a to ean-13 format disable 27 situation check point no picture 1. Check if the power supply is connected. 2. Make sure the p102-8 is turned on. No response from the remote control 1. Make sure there is a clear view between the remote control and the d...