EZ Breathe 400 Installation Manual - 7. Set Humidistat
7. SET HUMIDISTAT
7
8. SET SPEED CONTROL
PLUGGING IT IN
This component continuously monitors the humidity level of the air
being expelled through the EZ Breathe unit. You can set this control to
maintain the desirable level of humidity in your home/building.
For best results…
Set the humidistat between 35% to 40%.
Please note… even thought the ideal setting is 35%, this level of humidity,
due to environmental conditions, may not be obtainable even with an
EZ Breathe. Consequently, the EZ Breathe will run continuously. The
unit has been designed to perform under these conditions.
The rate at which you expel the damp air outside is adjustable with the
help of this control. When the humidity level is lower than the setting
on the humidistat, the appliance will turn off. In the cooler months,
you can set the fan on low and the humidistat to its lowest setting. This
very low speed will prevent a cold draft from entering your hours/building
while still allowing some ventilation for the removal of indoor pollutants.
For best results…
In the summer,
set the speed control
higher
In the winter,
set the speed control
lower
Your EZ Breathe unit can be plugged into any 110V electrical outlet. If
the cord is not long enough to reach your nearest outlet, an extension
cord may be used since the unit only draws approximately .34 amps
(the equivalent of a 40W light bulb).