Ez One Shot BAR CODE SCANNER User Manual - page 11
HOW TO CHANGE A CABLE
The CCD scanner are designed to switch easily between interface options.
To switch from one interface to another, the appropriate cable must be
installed. To change a cable, simply follow these steps:
1.To release the cable, insert a pin or straightened paper clip into the
hole at the base of the scanner where the cable is connected.
2. Remove the cable from the scanner.
3. Plug in the new cable.
After changing to a new cable, be sure to resetthe interface setting as
appropriate (including parameter settings for the RS-232 interface).
New Cable
Present cable
New Cable
Present cable
9
USB INTERFACES
The USB Interface supported is compatible with the Apple MAC series,
later PCs and Windows 98, 2000, Me, and XP.
1. Connect the USB cable between the scanner and the computer.
2. The scanner will beep.
3. The Scanner will detect the USB driver automatically. (The first time
the scanner is connected via the USB port, follow the appropriate
instructions for the host computer.)
4. Set the scanner to KEYBOARD/USB interface by referring to
GROUP-1 (Interface Selections).
5. Scanner will beep to confirm the setting.
6. Scan a bar code to confirm that data shows on the monitor.