Ez One Shot BAR CODE SCANNER User Manual - page 13
. A001$
COMPUTER TYPE
. C007$
NOTEBOOK*
MAC ADB
PC- AT
GROUP-1
INTERFACES SELECTION, COMPUTER TYPE, DEFAULT.
. C001$
KEYBOARD& USB
. C003$
WAND
. C008$
RS485
. C002$
RS232
INTERFACES SELECTION
DEFAULT
Caution: This scanner is designed to switch easily between interface
options. To switch from one interface to another, the appropriate
cable must be installed. After changing to a new cable, be sure
to reset the interface setting as appropriate.
. C006$
. C004$
SYMPTOMS
SOLUTION
Scanner seems to be
performing as usual,
but no data is being
output.
1. Unplug the cable from the host computer.
2. Plug the cable back into the host computer.
3. Set the scanner to the exact computer type
immediately.
SOLUTION
SYMPTOM
The wand does not
scan/ The scanner
does not scan when
the trigger is
depressed.
1. Unplug the cable from the host computer.
2. Plug the cable back into the host computer.
3. Set the wand to the correct interface. The
cable needs to match the interface.
11
Caution:Please ensure the correct computer type is set when the
scanner is attached to a new host computer. If set to Notebook, the
scanner will operate with no external keyboard.