EZip 300 Series Scooter Owner's Manual - Qr Lever Adjustment:

14

Customer Service 1-800-377-4532

Currie Technologies

®

qR LEvER ADjUSTMENT:

If the quick release lever is either 

too tight (cannot be flipped to its fully 

locked position) or is too loose (can 

be too easily flipped to its locked 

position) you will need to adjust the 

QR (Quick Release) Lever. 

Open the QR lever (Ref Photo A) and 

adjust the 10mm nut underneath the 

center pin (Ref Photo B).

If the QR lever was too tight initially 

you will need to loosen the nut a 1/4 

turn at a time. Test the adjustment 

you have made by closing the QR 

lever (Ref Photo C). The lever should 

be tight in its closed position and un-

able to vibrate loose.

If the QR lever was too loose initially 

you will need to tighten the nut a 1/4 

turn at a time. Test the adjustment 

you have made by closing the QR 

lever (Ref Photo C). The lever should 

be tight in its closed position and un-

able to vibrate loose.

Repeat adjustment as necessary 

until QR lever is properly tightened.

If you are unable 

to properly adjust the QR lever DO 

NOT RIDE THE SCOOTER. Contact 

Currie Technologies

®

 Customer 

Service at 1-800-377-4532 for further 

instructions. Failure to do so may 

result in serious injury or death to the 

rider or severe damage to the scooter.

Photo A

Photo C

Photo B

WARNING

!