EZip 300 Series Scooter Owner's Manual - Warning
30
Customer Service 1-800-377-4532
Currie Technologies
®
Proper braking performance is critical for safe riding.
Currie Technologies
®
strongly recommends that brake(s) be adjusted only by
a trained scooter or bicycle technician.
Do not ride the scooter in order to test the brake(s); it’s
easier and far safer to test the brake(s) as described above.
REAR WHEEL INSTALLATION
500CD, 650CD, 750CD AND 900CD SERIES SCOOTERS
The order of this installation is very important. Start with the chain pushed
over the frame so it can be placed on the large sprocket after the wheel is in
place.
Be sure the chain is between the wheel and rear sprocket.
1.
Install the rear wheel, large sprocket and motor plate assembly into
2.
the dropouts.
Install the kickstand onto the left side axle.
3.
Install retention washers both sides of the axle and
4.
loosely secure
with axle nuts.
Align the motor plate threaded holes to the frame tabs.
5.
Loosely se-
cure with the 5mm motor plate bolts.
Fully tighten both axle nuts at this time.
6.
Fully tighten both motor plate mounting bolts at this time.
7.
Install the motor onto the motor plate. Start by
8.
loosely securing the
motor with the top motor mounting bolt.
Pivot the motor clockwise in order to install the chain onto both the
9.
large and small sprockets.
Pivot the motor counter-clockwise and
10.
loosely secure the motor with
the lower two motor mounting bolts and T-nuts.
Adjust for proper chain and fully tighten all remaining bolts.
11.
WARNING
!
WARNING
!