EZip 300 Series Scooter Owner's Manual - Warning
32
Customer Service 1-800-377-4532
Currie Technologies
®
(if your scooter is equipped).
Slide the axle through one half of the rim, and place the center (lon-
11.
ger) axle sleeve over the axle at the center of the two rim halves.
Bolt the two halves of the rim together with the 5mm Allen bolts.
12.
Place the remaining axle sleeve and 17mm nut over the end of the
13.
axle. Center the axle by hand, then tighten both 17mm nuts against
each other.
Inflate the tire slowly to the recommended tire pressure. Inspect the
14.
tire during inflation to ensure it is seating onto the rim properly.
fRONT AND REAR WHEEL
500CD, 650CD, 750CD AND 900CD
SERIES SCOOTERS
Do not use a flat
screwdriver or other sharp metal tool
to remove the tire from the rim as this
may cause damage to the rim, inner
tube and/or tire.
To remove the front wheel refer
1.
to page 24 then proceed to step
3.
To remove the rear wheel refer
2.
to pages 26-27 then proceed to
step 3.
With a bicycle tire lever unseat
3.
one side of the tire from the rim.
(Ref Photo A, B, C)
Remove the tube from the tire.
4.
Slightly inflate the tube in order
5.
to inspect for leaks or punc-
tures. Patch or replace the tube
as necessary.
Carefully check the inside of
6.
the tire and remove any sharp
objects or debris that caused
the puncture. If the tire is cut
through in any place replace it
WARNING
!
Photo A
Photo C
Photo B