Ezy Gym FIT 150 Manual Manual - page 5
5 - Assembly
6 - Adjusting and testing
1. Put the Safety Key onto the Control Panel
2. Before turning on the power, please check: correct voltage, plug is properly grounded, the
running belt moves smoothly with no noise.
3. Press the On/Off button, the treadmill will run with a low speed (1.0km/h), observe if the machine
works normally
4. Press the Speed Up & Down buttons to see if the speed adjustment is working
5. Press the On/Off button again, the treadmill will stop, now pull out the plug.
1. Installing left and right column.
Insert left and right columns into bottom connector,
fix with M8 screws.
3. Installing sensor meter tube.
Fix the tube onto the two columns with M8 screws.
(After installing control panel, then tighten it.)
2. Installing the Control Panel.
Insert Panel into the two columns, then fix with M8
screws.
4. Installing the Gas Airspring.
Put the treadmill into the folded position first, then fix
Airspring onto the frame with M8 screws