F-SECURE POLICY MANAGER 8.0 Administrator's Manual - page 112
112
place the new hosts in the domain that you selected in Step 1, unless
you specified another domain in this dialog. You can also choose not
to place the hosts to any domain automatically. The new hosts will
send autoregs and the hosts can be imported that way.
7. After a few minutes, the Product View pane (the right pane) will list
the products that were installed. To see this list, select the Installation
tab in the Properties pane (alternatively select the top domain in the
Policy Domain pane).
5.4.2
Policy-Based Installation
Base policy files are used to start installations on hosts that have
F-Secure Management Agent installed. F-Secure Policy Manager
Console creates an operation-specific installation package, which it
stores on the F-Secure Policy Manager Server, and writes an installation
task to the base policy files (thus, policy distribution is required to start
installations). Both base policy files and the installation package are
signed by the management key-pair so that only genuine information is
accepted by the hosts.
F-Secure Management Agent on the hosts fetches the new policies from
F-Secure Policy Manager Server and discovers the installation task.
F-Secure Management Agent fetches the installation package specified in
the task parameters from the server and starts installation program.
When the installation is complete, F-Secure Management Agent sends
the result of the installation operation in an incremental policy file to the
server. F-Secure Policy Manager Console discovers the new status
information and shows the results.
Uninstallation uses these same delivery mechanisms. The results of the
uninstallation will not be reported.
If the installation fails, see
“
FSII Remote Installation Error Codes
”,
203 for explanations to most common error situations.