F-SECURE POLICY MANAGER 8.0 Administrator's Manual - page 30
30
Possible different installation scenarios for high security
environments:
1. F-Secure Policy Manager Server and F-Secure Policy Manager
Console will be installed in the same machine and access to the
F-Secure Policy Manager Server will be limited only to the localhost.
After this, only the person who has physical access to the localhost
can use the F-Secure Policy Manager Console.
When access to the F-Secure Policy Manager Server is limited only
to the localhost during the installation (see
Step 8.
, 40), F-Secure
Setup modifies the #FSMSA listen directive in httpd.conf file as
follows:
#FSMSA listen
Listen 127.0.0.1:8080 <- Allow connections only from
localhost to PMC port 8080
2. Access to F-Secure Policy Manager Server will be limited only to the
separately defined IP addresses by editing the httpd.conf file.
If the access to port 8080 was limited only to the localhost during
the setup, you should now open the port and then define the list of
allowed IP addresses (see the Listen 8080 directive in the example
below).