F-SECURE POLICY MANAGER 8.0 Administrator's Manual - page 32
32
Installing F-Secure Policy Manager Web Reporting in
High-Security Environments
F-Secure Policy Manager Web Reporting is designed to be used in
internal corporate networks for generating graphical reports of, for
example, F-Secure Client Security virus protection status and alerts.
F-Secure does not recommend using F-Secure Policy Manager Web
Reporting over public networks such as Internet.
Possible different installation scenarios for high security
environments:
1. Access to Web Reports is limited to localhost only during the
installation. After this, only the person who has physical access to the
localhost can use F-Secure Policy Manager Web Reporting.
When access to F-Secure Policy Manager Web Reporting is limited
only to the localhost during the installation (see
, 41), F-Secure Setup
modifies the #Web Reporting listen directive in httpd.conf file as
follows:
#Web Reporting listen
Listen 127.0.0.1:8081 <- Allow connections only from
localhost to Web Reporting port 8081
2. Access to F-Secure Policy Manager Web Reporting is limited only to
the separately defined IP addresses by editing the httpd.conf file (see
below)
If the access to port 8081 was limited only to the localhost during
the setup, you should now open the port and then define the list of
allowed IP addresses (see the Listen 8081 directive in the example
below).