Faber VASKA B11 Installation Manual - page 4
GB
GB 5
GB
GB 4
3. SAFETY INSTRUCTIONS
Safety and general information.
Before installation, ensure that the local distribution conditions
(identification of the type gas and pressure) and the adjustment of
the appliance are compatible.
This gas appliance is factory set and shall not be adjusted by the
installer.
G
Ge
en
ne
erra
all ssa
affe
ettyy
It is the law in the UK that a
allll gas appliances, are installed by a
competent person in accordance with the Gas Safety (Installation and
Use) Regulations (As amended), the relevant British Standards for
Installation work, Building Regulations, Codes of Practice and the
manufacturers instructions.
The installation should also be carried out in accordance with the
following where relevant;
The installation should also be carried out in accordance with the
following where relevant;
BS8303
BS5871 Part1
BS5440 Parts 1&2
BS715
BS6891
BS1251
Building Regulations and Standards issued as relevant by the
Department of the Environment or the Scottish Development
Department.
In the Republic of Ireland installation should be carried out in
accordance with IS813, ICP3, IS327, Building Regulations, Codes of
Practice, the manufacturers instructions and any other rules in force.
Failure to comply with the above could leave the installer liable to
prosecution and invalidate the appliance warranty
Note:
Since the appliance is a source of heat, circulation of air occurs.
Therefore it is of importance that you do not use the appliance shortly
after a renovation of the home. Because of the natural circulation of air,
moist and volatile components from paint, building materials, carpet
etc. will be attracted. These components can settle themselves down
onto cold surfaces in the form of soot.
As on all heat producing appliances, soft furnishings such as blown
vinyl wallpaper placed too near to the appliance may become scorched
or discoloured. This should be born in mind when installing the
appliance.