Faber VASKA B11 Installation Manual - page 8
GB 13
GB
GB 12
GB
8. DISPOSAL OF THE PACKAGING AND
THE APPLIANCE
The appliance packaging is recyclable. The packaging could include
the following materials:
- cardboard;
- CFC-free foam (soft);
- wood;
- plastic;
- paper.
These materials should be disposed responsibly and in conformity
with government regulations.
Information on how to responsibly dispose of discarded appliances
can be obtained from the local authorities.
PROBLEM
Appliance will not light
or goes out.
Poor flame distribution.
SOLUTION
- Venting.
- Check that the gas tap is
open and check the gas line
to see if it is dirty.
- Clean the burner carefully
with a vacuum cleaner.
- Check the thermocouple
circuit.
- The TSD switches on if
combustion gases flow into
the room because they
cannot escape through the
flue. Make sure that the flue
operates correctly and
provide good ventilation. If
the TSD comes into operation
frequently, you should
contact the installer.
- Arrange the log set properly.
- Clean the burner carefully
with a vacuum cleaner. Be
careful not to damage the
burner with the sharp edges
of the vacuum cleaner.
CAUSE
- Air in the supply pipe (after
appliance has not been in
use).
- Insufficient gas pressure.
- The pilot flame is dirty.
- The thermocouple contact
does not engage properly.
- The Thermal Safety Device
(TSD) is switched on.
- The logs are not positioned
properly.
- The burner is quite dirty
because of ash from
combustible materials has
gotten into the burner.
7. FAULTS