Factor V-1250x User And Installation Manual - page 9
V-1250x INSTALLATION INSTRUCTIONS CONNECTING SOURCES
IMPORTANT: THE STEREO ANALOG 3.5mm BUS INPUT WILL OVERRIDE THE STEREO OPTICAL INPUT. TO USE THE STEREO
OPTICAL INPUT DO NOT CONNECT TO THE ANALOG 3.5mm BUS INPUT.
The BUS INPUTS are the default inputs for all zones.
INSTALLATION: Connecting Audio Sources to the V-1250x
Use good quality RCA cables, 3.5mm stereo cables or SPDIF optical cables to connect to the V-1250x. Keep RCA cables and 3.5mm
stereo cables under 25' in length to avoid RF interference.
NOTE: EachV-1250x zone is capable of switching between the RCA LINE IN or the OPTICAL/ANALOG BUS IN independently.
Switching can be achieved using an (IR) Infrared system connected to the zone IR input, zone 12VDC LINE/BUS trigger input or RS232
commands with the V-1250x RS232 connected to a master control system. Controlling the input switching will be discussed in detail later
in this manual. The default input for each zone is the STEREO BUS 3.5mm stereo or SPDIF optical INPUT.
1. Connect a source to the BUS input, select REMOTE BYPASS ON for the selected zone. Audio will play at MAX volume.
2. Connect a source to the LINE IN, select REMOTE BYPASS ON for the selected zone. Apply 12VDC to the LINE/BUS TRIGGER
IN. Audio will play from the RCA LINE input at max volume.
3. Audio volume levels can be changed using Infrared or RS232 commands. Once a volume level is changed the V-1250x will
store the new level in memory and replay at the new volume level even if the master power switch is turned off.
www.factorelectronics.com
info@factorelectronics.com
Digital Optical
3.5mm Stereo
RCA Stereo
Apple TV Airport Express CD/DVD Player
9
9