Faderfox 4midiloop User Manual - page 7
Pushing button 1 in the FX3 section, defines the Led brightness 1 (dark).
Button 2 in the FX3 section defines the Led brightness 2.
Button 3 in the FX3 section defines the Led brightness 3.
Button 4 in the FX3 section defines the Led brightness 4 (bright).
Pushing button 1 in the FX4 section, defines „linear“ cross fader curve.
Button 2 in the FX4 section defines „rapid“ cross fader curve.
Button 3 in the FX4 section defines „switch“ cross fader curve.
Push the Preview Load and Favorites Prev buttons for about 2 seconds to leave the System Mode.
The System Led is off. Get Monitor state must be activated again
.
Blinking System Led indicates, that the 4midiloop controller is not yet recognized by the computer.
EQ Section
In the Xone-setting, the equalizer is a 4-band-EQ and can adjust the frequency content of the track
being played. Pressing the buttons next to the knobs switches the corresponding frequencies on or off
(Kill-function). The PFL Level Led’s display the pre-fader level of the deck’s signal in PFL mode (Pre
Fader Level). In AFL mode (After Fader Mode) the Led’s display the after-fader level of the deck’s
signal. The deck level can be adjusted with the Gain knob.
If the effect assign buttons FX1, 2, 3 or 4 are pressed, the corresponding deck to control slot 1,2,3 or
4 will be allocated.
The Filter potentiometer provides control over the bipolar channel filter. The filter can be activated by
pushing the button next to the knob. The centre position remains neutral. By turning the filter knob left,
it results in a low-pass filter and to the right, a high-pass filter.
The Key Lock potentiometer controls the track’s musical key. Turning it to the right, raises the key,
turning it to the left, lowers the key. The Key Lock can be activated by pressing the button next to the
knob.
Crossfader Section
The Deck assign buttonsassigns the desired decks left or right to the crossfader. The led for the
assigned deck flashes. You define which decks are audible on the left and right position of the
crossfader. A deck that is not assigned to one side of the crossfaderis only controlled by the channel
fader.
If Shift and Crossfader Left are pushed at the same time, the waveform display in the deck window
decreases. If additionally the Left Led flashes, the waveform display decreases the minimum. If Shift
and Crossfader Right are pushed at the same time, the waveform display increases. If additionally the
left Led flashes, the waveform display increases the maximum.