Faderfox micromodul uc4 User Manual - page 11
Setup mode
The setup mode allows selection of setups and routings. Further you can copy setups and group parts, reset
setups (factory reset) and send/receive setup data as sysex (backup/restore). Start setup mode by holding
shift key and press edit key twice. The activated setup mode is indicated by the red setup-LED. To leave
setup mode please press the edit button again without shift. Press any encoder shortly to see the function
behind.
To start any copy, paste, reset, send or receive function please hold down the encoder button (encoder 3 to 8)
while running bar lines shown in the display.
Setup and routing selection (encoder 1 and 2) works immediately.
Setup (Encoder 1)
SE01....SE18 select setup 1 to 18
Setup 17 and 18 are preconfigured for use with Ableton live 8/9.
Routing (Encoder 2)
Rou0
no Midi routing
Rou1
USB in to Midi out
Rou2
Midi in to Midi out
Rou4
Midi in to USB out
Rou5
Midi in to USB out + USB in to Midi out
Rou6
Midi in to Midi out + Midi in to USB out
Routing will be stored automatically by leaving setup mode.
Copy/Paste (Encoder 3)
CPYS
copy current setup completely
CPYn
copy group name of current encoder group
CPYE
copy encoder properties of current encoder group (not push buttons)
CPYP
copy encoder push button properties of current encoder group
CPYF
copy fader properties of current fader/button group
CPYb
copy button properties of current fader/button group
The last copies will be available in the copy memory permanently.
PStS
paste to current setup
PStn
paste group name to current encoder group
PStE
paste encoder properties to current encoder group (not push buttons)
PSTP
paste encoder push button properties to current encoder group
PSTF
paste fader properties to current fader/button group
PSTb
paste button properties to current fader/button group