Falcon Classic 110 Dual Fuel User Manual & Installation & Service Instructions

Manual is about: Classic toledo

Summary of Classic 110 Dual Fuel

  • Page 1

    110 dual fuel with fsd 110 mixte avec dss artno.000-0008 falcon logo shaded artno.000-0012 professional + logo user guide & installation & service instructions mode d'emploi & instructions d'installation & d'entretier u109772-05.

  • Page 2

    Contents before you start... 1 cooker overview 2 the griddle 4 the glide-out grill 5 the ovens 5 the clock 6 tips on cooking with the timer 8 general oven tips 8 oven cooking guide 9 oven shelves 10 the handyrack 10 main oven light 11 the browning element 11 storage 11 cleaning your cooker 11 troubl...

  • Page 3

    1 before you start... Thank you for buying the professional + cooker. It should give you many years trouble-free cooking if installed and operated correctly. It is, therefore, important that you read this section before you start, particularly if you have not used a dual fuel cooker before. This app...

  • Page 4

    2 do not use aluminium foil to cover shelves, linings or the oven roof. Never heat unopened food containers. Pressure build up may make the containers burst and cause injury. Do not use unstable saucepans. Always ensure that you position the handles away from the edge of the hotplate. Do not use coo...

  • Page 5

    3 when the igniter button is pressed in, sparks will be made at every burner – this is normal. Do not attempt to disassemble or clean around any burner while another burner is on, otherwise an electric shock could result. To light a burner, press the igniter button, and push in and turn a knob to th...

  • Page 6

    4 artno.311-0006 correct wok sizes the cradle should be used on the triple ring wok burner only. When you fit the cradle, check that the wok is properly located on the front and rear fingers and that it is supported properly on a pan support. Artno.311-0007 wok stand close-up make sure that the cradle...

  • Page 7

    5 the glide-out grill open the door and pull the grill pan carriage forward using the handle: artno.331-0001grill pan pulled forwards the grill has two elements that allow either the whole area of the pan to be heated or just the right-hand half. Adjust the heat to suit by turning the knob. To heat ...

  • Page 8

    6 the oven indicator light will glow until the oven has reached the temperature you selected. It will then cycle on and off during cooking: artno.270-0006 proplus oven control light 140 100 180 220 0 when cooking foods with high water content, there may be some steam visible at the grille at the rear...

  • Page 9

    7 to stop the oven at a specific time of day turn the timer knob to the ( ) position. Artno.301-0007 2bc stopping the oven 1 use the adjusting knob to set the time at which the oven is to stop. You can set the oven to turn on at any time over the following 24-hour period. Auto shows in the display: ...

  • Page 10

    8 the oven is now locked, as is confirmed by the display showing the time of day alongside the key symbol: artno.301-0013 2bc activating the key lock 3 when the key lock is activated, the left-hand oven can be operated as usual but the right-hand oven is locked and will not come on. To turn off the k...

  • Page 11

    9 artno.050-0003a - cooking table - electric & fan shelf position c c c c c c c c c c c c c t c/b c/b c/b c/b c/b c/b c c c c c c c c c c c c c/b c/t food meat beef (no bone) lamb pork poultry chicken turkey duck casserole yorkshire pudding fish fillet whole steak cake very rich fruit - christmas, w...

  • Page 12

    10 oven shelves artno.320-0009 oven shelf a - top view, b - side view, c - shelf guard, d - front the shelf guard should be at the back pointing upwards in addition to the flat shelves, some models are supplied with a drop shelf. The drop shelf increases the possibilities for oven shelf spaci...

  • Page 13

    11 main oven light press the button to turn the light on: artno.320-0026 - oven light if the oven light fails, turn off the power supply before you change the bulb. See the ‘troubleshooting’ section for details on how to change the bulb. The browning element the browning element is positioned in the ...

  • Page 14

    12 the wok burner the wok burner is a little more complicated but it can also be taken apart for cleaning. Artno.311-0014 wok burner details wok burner a - inner burner cap, b - outer burner cap, c - inner burner head, d - outer burner head, e - wok burner base when reassembling the wok bu...

  • Page 15

    13 if you need to remove the side rails to facilitate the cleaning of the grill chamber, you can unhook them from the grill chamber sides and wipe the sides clean with a soft cloth and mild detergent. Artno.331-0005 removing the grill rail do not use any abrasive substances. Do not put the side runn...

  • Page 16

    14 food is cooking too slowly, too quickly, or burning. Cooking times may differ from your previous oven. Check that you are using the recommended temperatures and shelf positions –- see the oven cooking guide. Then adjust the settings according to your own individual tastes. The oven is not cooking ...

  • Page 17

    Installation check the appliance is electrically safe and gas sound when you have finished. 15 installation dear installer before you start your installation, please complete the details below. If your customer has a problem relating to your installation they will be able to contact you easily. Insta...

  • Page 18

    Installation check the appliance is electrically safe and gas sound when you have finished. 16 you will need the following equipment to complete the cooker installation satisfactorily: stability bracket if the cooker is to be supplied with gas through a flexible hose, a stability bracket or chain must...

  • Page 19

    Installation check the appliance is electrically safe and gas sound when you have finished. 17 positioning the cooker the diagrams below show the minimum recommended distance from the cooker to nearby surfaces. The cooker should not be placed on a base. Artno.110-0035 110df prof+ min spacings ...

  • Page 20

    Installation check the appliance is electrically safe and gas sound when you have finished. 18 fit the levelling tool on the rectangular adjuster as shown below. Artno.010-0008 lowering the front rollers lower the front roller by doing 14 complete (360°) turns clockwise. (this means turning and ...

  • Page 21

    Installation check the appliance is electrically safe and gas sound when you have finished. 19 fitting a stability bracket a stability bracket or chain (not supplied by with the cooker) should be fitted when the cooker is connected to a flexible gas supply. When fitting a stability bracket read these in...

  • Page 22

    Installation check the appliance is electrically safe and gas sound when you have finished. 20 electrical connection this appliance must be installed by a qualified electrician to comply with the relevant institute of electrical engineers (i.E.E.) regulations and also the local electricity supply comp...

  • Page 23

    Installation check the appliance is electrically safe and gas sound when you have finished. 21 conversion to lp gas check in the 'technical data' section at the back of the instructions that the cooker is convertible to the gas you want to use. This conversion must be performed by a competent person,...

  • Page 24

    Warning - servicing to be carried out only by an authorised person disconnect from electricity and gas before servicing. Check appliance is safe when you have finished. 22 servicing before servicing any gas carrying components. Turn off the gas supply check the appliance is gas sound after completio...

  • Page 25

    Warning - servicing to be carried out only by an authorised person disconnect from electricity and gas before servicing. Check appliance is safe when you have finished. 23 feed the thermostat capillary out of the oven. Disconnect the wiring from the thermostat. Remove two screws holding thermostat t...

  • Page 26

    Warning - servicing to be carried out only by an authorised person disconnect from electricity and gas before servicing. Check appliance is safe when you have finished. 24 16. To change an oven door seal open the oven door. The seal is held in place by small hooks on the rear face. At the corner, pu...

  • Page 27

    Warning - servicing to be carried out only by an authorised person disconnect from electricity and gas before servicing. Check appliance is safe when you have finished. 25 22. To remove the left-hand oven bottom and top elements disconnect from the electricity supply. Bottom element pull the cooker ...

  • Page 28

    26 circuit diagram a b e f c d 1 2 ...

  • Page 29

    27 technical data this cooker is category ii2h3+ it is supplied set for group h natural gas. A conversion kit from ng to lp gas is packed with the cooker. Installer: please leave these instructions with the user. Data badge location: cooker back, serial number repeater badge below oven door opening....