Falcon Classic 110 Dual Fuel User's Manual & Installation Instructions

Manual is about: Classic toledo

Summary of Classic 110 Dual Fuel

  • Page 1

    User guide & installation instructions u108600-07 australia 110 dual fuel.

  • Page 2: Contents

    Contents 1. Before you start... 1 installation and maintenance 1 peculiar smells 1 if you smell gas 1 ventilation 1 personal safety 1 cleaning 2 2. Cooker overview 3 hotplate burners 3 wok burner 4 the wok cradle 5 the griddle 5 warmer 5 the grill 6 the ovens 7 operating the ovens 7 the clock 8 acce...

  • Page 3: 1.  Before You Start...

    1 this user guide covers a number of different models. Although some of the illustrations will look different to your particular model the functions will be the same. We hope the meaning is clear. N n this appliance is designed for domestic cooking only. Using it for any other purpose could invalida...

  • Page 4

    2 cooking high moisture content foods can create a ‘steam burst’ when an oven door is opened. When opening the oven stand well back and allow any steam to disperse. Artno.324-0001 steam burst n n always keep combustible materials, e.G. Curtains, and flammable liquids a safe distance away from your c...

  • Page 5: 2.  Cooker Overview

    3 2. Cooker overview the 110 dual fuel cooker (fig.2-1) has the following features: a. 5 hotplate burners including a warmer and wok burner b. A control panel c. A grill d. Main conventional oven e. Fan oven f. Storage drawer hotplate burners the drawing by each of the central knobs indicates which ...

  • Page 6

    4 the igniter should spark and light the gas. Keep holding the knob pressed in to let the gas through to the burner for about ten seconds. If, when you let go of the control knob, the burner goes out, then the fsd has not been bypassed. Turn the control knob to the off position and wait for one minu...

  • Page 7

    5 o o o o o o artno.311-0006 correct wok sizes the wok cradle the wok cradle is designed to fit a 35 cm wok. If you use a different wok, make sure that it fits the cradle. Woks vary very widely in size and shape. It is important that the wok sits down on the pan support – however, if the wok is too ...

  • Page 8

    6 warmer on the right of the hob is the warmer (fig.2-15). Use the warmer for keeping food warm while the final touches are put to a meal. Turn the control knob counter-clockwise to the ‘on’ position. For best results, preheat a covered serving dish for 10 minutes before adding food to it. Use only ...

  • Page 9

    7 the ovens the clock must be set to the time of day before the ovens will work. See the following section on ‘the clock’ for instructions on setting the time of day. References to ‘left-hand’ and ‘right-hand’ ovens apply as viewed from the front of the appliance. The left-hand oven is a conventiona...

  • Page 10

    8 artno.302-0001 - 6-button clock artno.302-0003 - 6bc minute minder setting 1 artno.302-0004 - minute minder setting 2 artno.302-0005 - 6bc stopping the oven 1 artno.302-0002 - 6bc annotated a b c d e f artno.302-0005a - 6bc stopping the oven 1a artno.302-0006 - 6bc setting the cook time artno.302-...

  • Page 11

    9 artno.302-0009 - activating the key lock 2 artno.302-0008 - activating the key lock 1 auto is showing, you want to reset to manual cooking to return to manual cooking from any automatic setting, the ‘cook period’ must be cancelled. Press and hold the [] button and then press the [–] button until ...

  • Page 12

    10 accessories oven shelves the oven shelves (fig.2-36) can be easily removed and refitted. Pull the shelf forward until the back of the shelf is stopped by the shelf stop bumps in the oven sides (fig.2-37). Lift up the front of the shelf so the back of the shelf will pass under the shelf stop and t...

  • Page 13: 3.  Cooking Tips

    11 3. Cooking tips tips on cooking with the timer if you want to cook more than one dish, choose dishes that require approximately the same cooking time. However, dishes can be ‘slowed down’ slightly by using small containers and covering them with aluminium foil, or ‘speeded up’ slightly by cooking...

  • Page 14: 4.  Cooking Table

    12 4. Cooking table artno.050-0007 oven shelf positions oven shelf positions top centre base the oven control settings and cooking times given in the table below are intended to be used as a guide only. Individual tastes may require the temperature to be altered to provide a preferred result. Food i...

  • Page 15: 5.  Cleaning Your Cooker

    13 artno.311-0032 burner layout fsd a b c d e artno.311-0033 wok burner details fsd a b c d e artno.311-0016 fitting the burner inner head a b fig.5-1 fig.5-2 fig.5-3 fig.5-4 a – cap, b – head, c – notch, d – base , e – electrode a – inner burner cap, b – outer burner head, c – inner burner head, d ...

  • Page 16

    14 grill the grill pan and trivet should be washed in hot soapy water. Alternatively, the grill pan can be washed in a dishwasher. After grilling meats or any foods that soil, leave to soak for a few minutes immediately after use. Stubborn particles may be removed from the trivet using a nylon brush...

  • Page 17

    15 removing the main oven linings some of the lining panels can be removed for cleaning. You will need to remove the shelves before removing the panels. Each side of the oven is fixed with four fixing screws. You do not have to remove the screws to remove the oven linings. Simply lift each side pane...

  • Page 18: 6.  Troubleshooting

    16 hotplate ignition or hotplate burners faulty is the power on? Is the clock illuminated? If not, there maybe something wrong with the power supply. Are the sparker (ignition electrode) or burner slots blocked by debris? Are the burner trim and caps correctly located? See the section on ‘cleaning’....

  • Page 19

    17 an oven light is not working the bulb has probably burnt out. You can buy a replacement bulb (which is not covered under the warranty) from a good electrical shop. Ask for a 15 w – 230 v lamp, for ovens. It must be a special bulb, heat resistant to 300 °c (fig.6-1). Turn off the power at the circ...

  • Page 20: 7.  Installation

    Installation check the appliance is electrically safe and gas sound when you have finished. 18 7. Installation service and spares firstly, please complete the appliance details below and keep them safe for future reference – this information will enable us to accurately identify the particular appli...

  • Page 21

    Installation check the appliance is electrically safe and gas sound when you have finished. 19 dear installer before you start your installation, please complete the details below, so that, if your customer has a problem relating to your installation, they will be able to contact you easily. You mus...

  • Page 22

    Installation check the appliance is electrically safe and gas sound when you have finished. 20 checking the parts: you will need the following equipment to complete the cooker installation satisfactorily: • flexible gas hose. • gas pressure tester/manometer. • multimeter: for electrical checks. You ...

  • Page 23

    Installation check the appliance is electrically safe and gas sound when you have finished. 21 positioning the cooker the diagram (fig.7-1) shows the minimum recommended distance from the cooker to nearby surfaces as given in as 5601. 1. Overhead – measurement a the minimum height of any surface abo...

  • Page 24

    Installation check the appliance is electrically safe and gas sound when you have finished. 22 moving the cooker n n on no account try and move the cooker while it is plugged into the electricity supply. N n the cooker is very heavy, so take great care. We recommend that two people manoeuvre the coo...

  • Page 25

    Installation check the appliance is electrically safe and gas sound when you have finished. 23 cooker outer stability bracket floor wall 3 mm min typical wall mounting artno.070-0014 - stability bracket - wall fitting cooker stability bracket floor 3 mm min typical floor mounting artno.011-0007 - re...

  • Page 26

    Installation check the appliance is electrically safe and gas sound when you have finished. 24 levelling you are recommended to use a spirit level on a shelf in one of the ovens to check for level. Place the cooker in its intended position taking care not to twist it within the gap between the kitch...

  • Page 27

    Installation check the appliance is electrically safe and gas sound when you have finished. 25 artno.110-0011 110 df gas hose connections 600 100 350 250 gas inlet block all dimensions in millimetres fig.7-12 gas connection must be in accordance with the relevant standards. The gas supply needs to t...

  • Page 28

    Installation check the appliance is electrically safe and gas sound when you have finished. 26 electrical connection this appliance must be installed by a qualified electrician to comply with the relevant regulations (as/nzs 60335.2.6) and also the local electricity supply company requirements. Make...

  • Page 29

    Installation check the appliance is electrically safe and gas sound when you have finished. 27 artno.350-0012 - securing the plinth fig.7-17 final checks hotplate check check each burner in turn (refer to the ‘hotplate burners’ section at the front of the instructions). Grill check turn on the grill...

  • Page 30: 8.  Conversion to Lp Gas

    Warning – servicing to be carried out only by an authorised person disconnect from electricity and gas before servicing. Check appliance is safe when you have finished. 28 a b c artno.311-0010 injectors fig.8-1 a – jet, b – internal injector, c – external injector artno.0102-0001 - unscrewing the co...

  • Page 31

    Warning – servicing to be carried out only by an authorised person disconnect from electricity and gas before servicing. Check appliance is safe when you have finished. 29 set the governor unscrew the governor’s brass top. In the base of the brass top is a plastic snap-in converter device (fig.8-4)....

  • Page 32: 9.  Servicing

    Warning – servicing to be carried out only by an authorised person disconnect from electricity before servicing. Check appliance is safe when you have finished. 30 a b c a – flue grill, b – cooker backsheet, c – earthing/fixing screws a b c a – flue grill, b – cooker backsheet, c – earthing/fixing s...

  • Page 33

    Warning – servicing to be carried out only by an authorised person disconnect from electricity before servicing. Check appliance is safe when you have finished. 31 right-hand tray from the rear remove the screws securing the flue grill to the hotplate tray. If the left-hand hotplate has not been rem...

  • Page 34

    Warning – servicing to be carried out only by an authorised person disconnect from electricity before servicing. Check appliance is safe when you have finished. 32 3.2 to replace the clock disconnect from the electricity supply. Remove the control panel (see 1.1). Pull off the timer control buttons....

  • Page 35

    Warning – servicing to be carried out only by an authorised person disconnect from electricity before servicing. Check appliance is safe when you have finished. 33 artno.320-0020 oven back fixing screws fig.9-5 remove the screws securing the electric cover to the back sheet, and then remove cover an...

  • Page 36

    Warning – servicing to be carried out only by an authorised person disconnect from electricity before servicing. Check appliance is safe when you have finished. 34 fit the replacement control and re-assemble in the reverse order. 5.5 to remove the right-hand oven element disconnect from the electric...

  • Page 37

    Warning – servicing to be carried out only by an authorised person disconnect from electricity before servicing. Check appliance is safe when you have finished. 35 artno.320-0005 oven door rubber seal artno.320-0002a proplus oven door side screws artno.320-0006 oven door hinge adjustment 1 artno.320...

  • Page 38: 10.  Circuit Diagram

    36 key the connections shown in the circuit diagram are for single-phase. The ratings are for 230 v 50 hz. P095199 1 2 p2 p1 p1 p2 p3 1 2 4 3 5 p093292 e 1 2 1 2 p1 p2 p3 1 2 4 3 5 p025635 a b e f c d 1 2 b b b b b b b b b b b b b b b b b b br br br br br br br bk bk bk y y y y y y y y y y y or or v...

  • Page 39: 11.  Technical Data

    37 11. Technical data this cooker is designed for use on natural gas but can be used converted to lp (propane x (2.54 kpa)). A conversion kit from natural gas to propane is supplied with the cooker. Installer: please leave these instructions with the user. Data badge location: cooker back, serial nu...

  • Page 40

    Clarence street, royal leamington spa, warwickshire, cv31 2ad, england. Tel: +44 (0) 1926 457400 fax: +44 (0) 1926 450526 e-mail: consumers@falconappliances.Co.Uk.