Falcon TBM-18 Operating instructions manual - page 19
3
Installation:
Jewel box Video Camera (Model #TJM-275)
1. Power by either the Battery and DC power of the Jewel box video camera.
2. Position the video camera in the desired location.
NOTE: The transmission range of the Jewel box video camera at open side up to 150 ft. Real
distance is depends on its operating environment. If you are receiving poor video images from
the camera, try shortening the transmission range. Reposition and/or adjust the Jewel box
video camera if video transmission is being degraded by obstructions in its operating
environment.
3. Select the desired transmission channel for the Jewel box video camera.
NOTE: The Model #TJM-275 Jewel box video camera has four (4) different transmission
channels. The Jewel box video camera has been set to transmit on CH 1 at the factory. Do not
set and/or use more than one (1) video camera on the same transmission channel in order to
prevent signal interference and unclear picture reception.
4. Connect DC Input Jack or connect the AC Power Adaptor Jack end to the DC Input Jack end
of the Jewel box Video camera.
5. Plug the AC Power Adaptor into a standard 120V AC electrical outlet.
6. Unplug the AC Power Adaptor from the electrical outlet when it is not in use or is left
unattended.
Receiver (Model #VSB8RX):
CAUTION: Make all of the necessary wire jack connections before plugging the AC Power
Adaptor into an electrical outlet, as a risk of electrical shock may exist. Keep away from water,
fire raindrop and high humidity
1. Insert the 3.5Ø cable plug into the Video Output Jack of the receiver.
2. Insert the (yellow ) cable plugs into the Video Input Jack of your TV, as appropriate.
Jewel Box
Video Camera
2.4GHz
Receiver
(VSB8RX)
Yellow
Plug
Video Cable
TV
Video
Input
Jack
3.5 Plug
Audio
Input
Jack