Fält Communications AB 252236 User Manual - page 10
162236M User Manual GSM Gateway
10
SMS to GSM Gateway
SMS from GSM Gateway
To reactivate the dial tone 2 (battery alarm/low battery voltage indication, dial tone); send the left side
SMS to the GSM Gateway. The Gateway will return the answer on the right side.
SMS to GSM Gateway
SMS from GSM Gateway
5.3 Status
Get current status of the GW by sending a “Status” SMS. The SMS must contain the SMS Access code followed
by a new line and the word Status. The default Access code is 1111 and can be changed using the FältCom
Manager SW. If the access code or the request command (Status) is incorrect the GSM Gateway will not answer
the SMS.
SMS to GSM Gateway
Example SMS from GSM Gateway
Description table of the status SMS:
Parameter
Description
SN
Serial number of the Gateway
FW
Firmware version of the Gateway
S
Current signal strength (signal strength in dBm)
S H/L
Highest signal during last 24h/lowest signal during last 24h since last restart
UT
Uptime counter, presented in days, hours and minutes.
LC
Last called number, not saved in case of restart.
PWR
Current power source – Mains or Battery
Dial tone2:off
Dial Tone2: OFF
Dial tone2:on
Dial Tone2: ON
1111
Status
SN:V12345
FW:3.19
S:31 (-51)
S H/L:2/31 (-109/-51)
UT:450d21d22m
LC:0701234567
PWR:Battery
LRR:Reset
Op:Vodafone
CID:25781258
LAC:65534
Line:On
LHoff:02d01h36m