Fält Communications AB 252236 User Manual - page 11
162236M User Manual GSM Gateway
11
LRR
Last restart reason
xxx1
Power on
xx1x
External reset
x1xx
Watch-dog reset
1xxx
Low voltage reset
Op
Current operator in use, in text format
CID
Cell ID of the base station
LAC
Location area code of network cell
Line
POTS line On-hook or Off-hook
LHoff
Time since last hook-off, presented in days, hours and minutes
6. Upgrade Tool
The USB interface is used to configure user specific parameters and to upgrade the GSM Gateway
firmware. The upgrade
requires the Windows program “FältCom Manager” and is available from
FältCom or your local distributor. Use a standard USB
– mini USB cable to connect the GSM Gateway
to the PC.
-
Install the “FältCom Manager” tool on your PC.
-
Connect the GSM Gateway to the PC using a standard USB
– mini-B USB cable.
-
Start the “FältCom Manager” by clicking
the icon
When the GSM Gateway is connected to the Manager tool the status bar at the bottom will show
“1258 connected”
Push “Get” to see the GSM Gateway Firmware and Hardware versions. In this example FW 3.20 and
HW 003.
6.1 Firmware upgrade
To upgrade the GSM Gateway Firmware select the “FW update” tab.