Fanimation Treventi FP2500 Series Owner's Manual - page 5
5
How to Assemble Your Ceiling Fan
Pin
Setscrew
Hanger
Ball
Figure 5
1. Prior to assembly, set aside and save the hardware
bag(s) packed in the packing.
2. Remove the Hanger Ball by loosening the setscrew
in the Hanger Ball until the ball falls freely down the
Downrod. (Figure 5) Remove the Pin from the Downrod,
then remove the Hanger Ball. Retain the Pin and Hanger
Ball for reinstallation in Step 5.
3. Separate and untwist the two wires and the safety
cable. Route the leads through the Downrod.
4. Loosen the two setscrews in the Downrod Support.
Align the Clevis Pin holes in the Downrod with the holes
in the Downrod Support. Install the Clevis Pin and secure
with the Hairpin Clip. (Figure 6)
How to Assemble Your Motor Housing (cont'd)
3. Be sure the threaded holes in both the Motor Adapter
and the Housing are aligned before screwing the Captive
Screws. (Figure 3)
Captive Screw
(4 places)
Motor Adapter
Motor
Housing
4. Align the Screw Locator Holes (on Blade Holder
Flange) over the Captive Screw Head, tighten and secure
the Housing onto the Motor Adapter. (Figure 4)
Captive
Screw
(4 places)
Screw
Locator
on Blade
Holder
Flange
(6 places)
Figure 4
Figure 3