Fantasia Medina Owner's Instruction Manual - page 12
12 of 20
4. Adding a light kit
To install an optional light kit first ensure all pole disconnection of the electricity supply.
Then unscrew the three screws at the bottom of the switch housing and remove the
switch housing plate. Your light fitting will either replace this plate entirely or will
connect on to the plate via the push out centre stud. (Refer to instructions that are
supplied with your light fitting ). The light is then offered up to the switch housing.
Locate the two cables marked “for light’. Connect the blue and orange cables with their
corresponding colour cables on the light fitting. The orange wire is the ‘live’ supply for
the light and the blue wire is the ‘neutral’. The connection is made with push together
connectors.
When assembling the lighting attachment back onto the fan ensure there are no cables
trapped between the metal surfaces. Also ensure that there are serrated washers on the
three screws at the bottom of the switch housing. This ensures good earth continuity to
the light.
Fit the bulbs.
Clip the dangler for the light onto the pull chain
Product Disposal Instructions
This product has been classed as Electrical or
Electronic Equipment and should not be
disposed of with other household or commercial
waste at the end of it’s working life.
The Waste of Electrical and Electronic
Equipment (WEEE) Directive (2002/96/EC) has
been put in place to recycle products using best
available precise and minimize the impact upon
the environment.