Fantasia Medina Owner's Instruction Manual - page 13
13 of 20
5. Assembling the blades
The acrylic blades now need to be assembled
on to the carrier brackets.
Carefully unwrap the carrier bracket.
Align the bracket with the holes in the
blades and use the screws and fibre washers
provided to connect them.
The fibre washer should go on top the blade
between the head of the screw and the
surface of the blade. Ensure the screws are
tightened up firmly.
6. Attach the assembled blades onto the fan
Using the coarse threaded short bolts
and the spring washers provided, bolt
the carrier bracket on to the motor.
Ensure the bolts are tightened firmly.
Be careful not to bend the carrier
brackets during installation as this may
result in an imbalance and induce
wobble.
If installing more than one fan be careful not to mix the blade sets. Each set is carefully
manufactured to be evenly balanced, mixing would break up a balanced set and again
this could induce wobble.
There is a anti-water cover attached
with fan that coving pull switch for
water proofing, please don’t lose when
the fan is unpacked and make sure the
anti-water
cover
is
at
properly
position.