Fantec mr-35hdc hard disk copystation user manual red=raid blue=dup power copy compare prescan erase raid0 raid1 big jbog start mute reset raid dup.
Menu 1 menu ............................................................................................................................ 1 1. Product introduction .............................................................................................................. 2 2. Operation in raid fun...
Front back 1. Product introduction 2 sata hdds to usb 2.0 interface. 2 21 7. Operation in dup function (duplicate) raid dup attention: please set the switch to dup operation. Raid dup r e d = r a i d blue = dup power copy compare prescan erase raid0 raid1 big jbog start mute reset raid dup dup raid ...
2. Operation in raid function 3 note:sway from side to side the lock at the instructed point , which you could open the doorknob to install/ unload the hard disk. In contrast, when you sway from side to side the lock at the instructed point , then you may not open it. The hard disk installation:sway...
The result of extending the hard disk partition/volume is illustrated below. Before extend: 2. At a command prompt, type diskpart. Note: before the hard drive partition/volume has been extended the “152.67gb unallocated” was not accessible for data usage. After using the disk part utility to extend ...
Led condition: switch on power and press “start” button in terms of different working pattern the following led condition will display a hdd damage under the different working pattern. The explanation describes the case of hdd1 normal, hdd2 faulty, otherwise the opposite way around.) 5 perform simil...
The safe storage policy stores all data in duplicate on separate drives to protect against data loss due to drive failure. One drive mirrors the other at all times, equivalent to raid 1. Every write operation goes to both drives. Safe provides the highest level of data protection for critical data t...
Click “ ” plan: right pop-up the additional disks ( :)' menus, choose “ ”. Click “ ”, followed by a clew to operate. Disks management h delete disk segmentation segmentation additional disks 7 click “ ” plan: right pop-up the additional disks (h :) and the additional disks (i :)' menus, choose “ ”. ...
Usb features 4.2 serial ata hdd 4.3. Four working mode big jbod,raid0/fast,raid1/safe big the fantec mr-35hdc provides the following universal serial bus (usb) features: usb 1.0 and usb 2.0 specification compliance for detailed information about usb technology, refer to the following specifications ...
2.1.4 raid1/safe raid1 reset + start my computer manage the two drives were connected to the products hdd1 and hdd2 connector; usb & power cable were connected. Press power switch, set mode switch to and press button. After a few seconds, the computer will automatically capture usb devices and incre...
8. Name and format the partition and click . 9. Review the file system settings and click to create the logical partition. Important: before reconfiguring a volume, back up your data and drag the old drive to the trash to un-mount previously defined partition. If no hard drives are connected to the ...
Every disk should appear with the word “ ”, a size value that shows the available storage capacity, and a status of “ ”. Instead of basic, a disk could appear , , or . If the disk appears as “ ”, right-click the disk icon and select . A window opens with the selected disk (all unknown disks may appe...
