Fantec MR-35HDC User Manual - page 5
The result of extending the hard disk partition/volume is illustrated below.
Before extend:
2. At a command prompt, type diskpart.
Note: Before the hard drive partition/volume has been extended the “152.67GB
Unallocated” was not accessible for data usage. After using the disk part utility to
extend the hard drive partition/volume capacity, the Windows host side matches
the virtual hard drive partition/volume.
5. Quick Start Operation in RAID Mode
(
Note:
1) Pull the doorknob to insert hard disks.
(2) Set the function button to RAID Operation
(3) Choose the RAID mode which you want use (RAID0/1/JBOD/BIG)
(4) Connect the power cord to power outlet.
(5) Push down the Power button.
(6) The front panel will display:
Power LED On:
Blue
Operation LED On:
Red
Function LED On:
Green
The function LED flashes according to your selected RAID mode.
For example, if you select “RAID0”, LED next to “100%” will flash.
(7) The unit will detect HDD automaticly and HDD status LED will red twinkle during this
time. After the detection has finished, the HDD status LED will become purple and
function LED will twinkle in green.
(8) Press the “Start” button for more than 2 seconds and a buzzer will beep for two times.
Now the system will start to change the mode.
19
4
Connect to the computer host through USB, turn on the power and press the
“Start” button (Instruction will be presented in the following graph).
Turn the switch to RAID0, LED will keep bright and the host will be entering the
RAID0 active status.
Turn the switch to RAID1, RAID1 LED keep bright, and the host will be entering
the RAID1 active status.
Turn the switch to JBOD, JBOD LED keep bright, and the host will be entering the
JBOD active status.
Turn the switch to BIG, BIG LED will keep bright, the host will be entering the BIG
active status.
Hard disk LED "
"/"
" sends blue light and has long-lasting bright light, which
indicates the hard disk connection is correct.
Hard disk LED "
"/"
" sends the pink light and does not stop glittering, which
indicates the hard disk is performing material transmission.
Hard disk LED "
"/"
" sends red light and
, which
indicates a hard disk connection error.
has long-lasting bright light
to AC90-240V
USB Port to PC host
USB
AC 90V-240V