FARFISA INTERCOMS DVR42E User Manual - page 12
How to operate motion detection recording
Follow the steps as described here
below to activate motion-detection
recording.
1.Please go to “SENSOR SETUP”
menu as the left figure shown.
2. Select out the motion option.
3. After the selection, please be back
to MAIN MENU and come back to
“PROGRAMMED RECORD” to select
the alarm (S) setting.
Notice: The setting under
“PROGRAMMED RECORD” is
necessary for starting the
operation of motion detection
recording.
Playback
Use the front panel buttons to
operate various playback
functions.
Press “
►
” button, then the
playback time /events
selection menu as the left
figure appears on the screen.
Or you can simply press “
►
”
twice to directly start playing.
You can either enter the specified time/date to playback or select the event or
even view the playback over PC.
Notice
1. Stop recording before activate a playback.
2. Because the events selection is default setting, so you need to press “
►►
”
button to switch to time selection.
3. Press “
►
” button to see new created (by overwriting) files list. (It can list up
to 64 files.) Choose desired video file by moving up/down buttons and press
“
►
” once again to play.
Press “
►►
” button to see the whole recorded time range (begin to end)
including any non-overwrited video. If any desired date and time is out of this
time range, there won't be any video exist (means either overwrited or not
recorded). To search desired date and time, press up/down buttons to move
the cursor to the positions of beginning date and time and press Enter button
to change for desired date and time numbers. Then, press “
►
” button to play.
Control buttons
SENSOR SETUP
SENSOR RECORD TIME 15
ALARM OUT TIME 20
MOTION SENSITIVE SETUP
CHANNEL-1 TYPE:MOTION + N-C
CHANNEL-2 TYPE:MOTION + N-O
CHANNEL-3 TYPE:NORMAL CLOSE
CHANNEL-4 TYPE:NOT INSTALLED
PRESS (
#$
), THEN ( )
PRESS(
!
) TO EXIT
PROGRAMMED RECORD
+ T T T S S T T T T T T T T T +
0 3 6 9 12 15 18 21 24
PRESS (
#$
), THEN ( )
PRESS(
!
) TO EXIT
SEARCH TIME
HDD: MASTER
04/03/24 13:24:21-04/03/24 13:44:54
>01 TIME 04/03/24 13:24:21
>02 TIME 04/03/24 13:30:55
>03 TIME 04/03/24 13:40:54
(
#$
) MOVE,( )