FARFISA INTERCOMS DVR42E User Manual - page 5
Power up the unit
After the unit is properly installed, the DVR is ready to record and play. Then
apply power supply provided and switch on.
After the unit is powered on, the
unit will check the HDD for
several seconds. The
information shown will be as:
The unit will enter into real-time
display mode shown in the
figure.
Notice:
To resume factory default
settings, push 5 time
#
button
and the message “Turn off and
on the DVR” will be displayed.
Then to complete the reset
operation, turn off and on the
DVR.
The above procedure will not
delete the images recorded in
the HDD.
The On Screen Display
HDD CHECKING
OK
CH1 CH3
CH3 CH4
Turn off and on the DVR!
Press
"
button to
stop playback
SEARCH TIME
HDD: MASTER
04/03/24 13:24:21-04/03/24
13:44:54
>01 TIME 04/03/24 13:24:21
>02 TIME 04/03/24 13:30:55
>03 TIME 04/03/24 13:40:54
(
#$
) MOVE,(
"
)
CHANGE,(
!
)PLAY
MAIN MENU
CAMERA SELECT 1234
RECORD SELECT 1234
RECORD MODE EACH
RECORD FRAMERATE 25
VIDEO QUALITY HIGH
RECORD SCHEDULE
SUB MENU
HARD DRIVE SETUP
SENSOR SETUP
Press
!
button
to display OSD menu
1. Power on the system
●
●
●
●
CH1
●
●
●
●
Press
!
button to exit
OSD menu to real-time
display
Press
%
button to
start recording
Recording Mode Display
OSD Mode Display
Search Mode
CH1
CH3
Playback mode
Press
!
button to
search time or event to
playback
Press
"
button to stop
recording (password is
requested!)
Press
!
button to exit
the menu
Press
!
button to
start playing
CH1
CH3