Faroudja Native Rate Series Installation And Operation Manual - page 6
SETUP
5
• Press the Enter button, the Preset LEDs turn
Red, the Enter LED turns Green. (Press Enter
again to cancel procedure)
• Press the Preset you want to use and the LED
on that Preset will turn green and the LED on the
Enter will go out.
NOTE: When Functions are accessed via the
front panel controls the On-Screen-Display is
not activated.
SYSTEM SETTINGS AND SETUP
Setup offers functions that must be done when the
unit is initially installed. Some user features are not
available with a few of the Setup selections so this
must be done first. To prevent accidental alteration
of the setup parameters, some setup functions can
only be done from the front panel or with the
RS232 interface.
System Settings - Press Enter
There are four sections to the System Setting:
• System Menu
• User Mode
• I/R Setup
• Test Patterns
System Menu - Press Enter
Pressing the Function Up will recall the following
commands in this order. Press the Value Up or
Down key to select or change values. When no
commands are entered after a short period the
front panel LCD will switch to the main window.
Just hit Function or Value to jump back to the
control menu last used.
Exit System Settings- press Enter
Returns to the User Menu
RS232 Echo:
On(Default)/Off
Select if the RS232 commands returns a status
report to the control system.
DCDi Mode:
On (Default)/ Off
Should always be On
Film Mode:
On (Default)/Off
Should always be On
LCD Display Backlight Timer
5-255 (Default 10)
Sets how long the front panel LCD stays on.
Red LED Brightness
0-15 (Default 8)
Front panel LED brightness
Green LED Brightness
0-15 (Default 8)
Front panel LED brightness
OSD Vertical Position
0-255(0=Top)
This sets the position of the single line
adjustment OSD
OSD Timer
4-255 seconds (10 Default)
HDTV External Input
Pass-thru
YPrPb to RGB
NOTE: The HD Pass-through input can transcode
YPrPb HDTV signals to RGBHV. It cannot
transcode RGBHV signals to YPrPb.
NOTE: Sync on Green is NOT available when
using the HD Pass-through input.
The following commands allow for separate set-
tings for each aspect ratio. First select the aspect
ratio that needs adjusting before beginning.