Faroudja Native Rate Series Installation And Operation Manual - page 7
It is recommended that sizing and blanking adjust-
ments be done with the display device controls
first to insure proper settings before using the fol-
lowing commands.
Bottom Blanking
Right Blanking
Left Blanking
Top Blanking
Image Vertical Position
Moves image up from center
Image Horizontal Position
Moves image left or right of center
Pass RGB Input Sync
Sync on Green
Ext. Sync High/Low
(Low sync is used with PAL sources where com-
posite video is applied as sync with RGB)
Composite Sync on H
On/Off
Sync on Green
On/Off
(Default)
(Comp. Sync on H and Sync on Green Functions
are only available if RGB output is selected.)
Output Format
RGB(Default)/YCrCb/YPrPb
Screen Shape
4:3 / Wide / Wide 4:3
• 4:3 – Choose this when the projector is 4:3
and the screen is 4:3
• Wide – Choose this when the screen is
Widescreen and the projector will provide
the anamorphic vertical squeeze.
• Wide 4:3 – choose this when the projector
is 4:3 only and the screen is Widescreen.
(Not available on units scanning at rates
below 720p)
I/R Setup - Press Enter
Use this section to teach learning remotes the
direct access codes. See the IR Setup section on
page 10 for details.
Test Patterns-Press Enter
Use these patterns to adjust the image and
processor. Use the Value key to select the different
patterns. Once the pattern is selected press the
Function key to return to the User Menu and then
select the proper setup Function. Once adjustment
is set, use the Function key to return to Test
Patterns - Press Enter and select Test Patterns
Off. Accessing the test patterns is easiest using
the OSD.
Off
PLUGE
100IRE Window
Active Boarders
Convergence
Blue
Red
Green
Cr Ramp
Cb Ramp
Luma Ramp
10-step Gray Scale
100IRE Rev. CB
100IRE CB
User Mode-Press Enter
These are the controls that are used most often.
Noise Reduction
0-15, Factory 8
Detail
0-31, Factory 8
Tint
0-255, Factory 128
Color
0-255, Factory 128
Contrast
0-155, Factory 128
Brightness
0-170, Factory 128
6
SETUP