Faytech 0700 SI User Manual - page 19
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
Speakers
Infrared receiver
MODE: switch from VGA to AV1 to AV2. Make sure the input source is
correct or you will not see any image on your screen
MUTE: turn speakers on or off
VOL-: reduce the volume –or- navigate in the OSD menu –or- change the
highlighted values in the menu
MENU: open the OSD menu –or- confirm selection in the OSD menu
VOL+: increase the volume –or- navigate in the OSD menu –or- change
the highlighted values in the menu
BRIGHTNESS: change the brightness of the display
PWR: turn the display on or off
Earphone out
For the internal power supply of the PC: +12V, GND, Reversing light
USB connector for the touch function
2x Video connectors, 4x Audio connectors
VGA connector to PC
All-In-One cable with VGA, USB, power, video and audio connections.
Connect to input (29)
120 or 220VAC adapter connects to input (26)
120 or 220VAC power plug
12V adaptor connects to input (26)
12V adaptor to cigarette lighter
Mounting case
Touch pen (only for display with touch function)
Remote control for the display
Driver CD (only for display with touch function)
User's guide
Holder for touch pen
12V DC power input
Extended USB port to PCs; see section 5 of Display Connections
Speakers
All-In-One cable (15) input
Display stand
Components:
faytech Ltd. 2009
C
32
Each cable is labeled for easy connection. To operate your faytech display
properly, there must be at least one signal source and a power supply
connected. If you have the optional touch screen and you want to use it, you
also must have the USB port connected to your PC.
To connect the
, you have the following options:
On a PC: Connect the VGA cable from the faytech monitor to the VGA output
of your PC graphics card. Please select MODE VGA / RGB, so you have an
image on the display.
On a PC: If you have only one DVI output on your PC, please purchase a DVI
to VGA adapter and connect the display via VGA to your PC.
To DVD-Player/camera/Video source: Connect one or two video inputs
(labeled Video1 or Video2) to a corresponding video source. Please be sure
to switch off the video source before you connect the cables. Switch MODE to
the respective channel input (AV1 or AV2).
1.
signal source
l
l
l
In addition, the display has two stereo audio inputs, one for the PC (red and
white RCA connectors, labeled with PC AUDIO-L and PC AUDIO-R) and one
for the two video inputs (sound is carried on both channels), also a white and
red RCA connector, labeled with AUDIO1-L and AUDIO1-R . Audio comes
through the speakers only if there is an image signal. Audio is also available
from the earphone output on the front side of the display. If earphones are
connected, the built-in speakers will not be active.
2.Connect power using only one of these options (do not try to connect more
than one power source at the same time):
Display Connection
You can use the display simultaneously with all three video
signal sources. Use the MODE button on the display or the
MODE button on the remote control to switch between the
various signal inputs.
Tip:
33