Faytech 0700 SI User Manual - page 25
Start the administration program by going to “Start - Programs -TouchKit –
Configure Utility”. (If you accepted all the defaults the program may be at “Start –
Programs – Accessories – Touchkit – Configure Utility”.) Or you can find this
program in the system tray section of your task bar.
1.General
2. Setting
linearization
Tools - linearization setting
Double Click Time
Shorter <<
>> Longer
Double Click Area
Smaller <<
>>
Larger
tab
Gives information on whether one or more touch controllers are found and
installed.
After the initial installation, if no touch controller shows up on this tab, please
pull out the USB connector on your PC and connect the device again.
tab
When you touch the touch panel there is a beep if you select the first checkbox.
You can change the frequency and duration of the beep. The changes will be
saved after you click on "OK".
Under
, you can choose the number of linearization points under
the
. On a 25-point linearization the deviation of a
touched point will be less than on a 9-point linearization. In general, the faytech
displays have been set correctly and should not be linearized.
. You can set how fast you need to click on the same object
to make a double click. If you choose
, then you need to tap faster. If
you choose
, then you can tap the screen more slowly..
The same applies to
. If you choose
, your taps
must be in a relatively small area in order for a double click to be recognized.
enables you to make a successful double- click within a larger area.
Setting up the faytech Touch software
faytech Ltd. 2009
C
44
Setting up the faytech Touch software
Normal-Mode
Click on touch
Click on release
function in touch
Click on touch without moving cursor
Click on release without moving cursor
: Allows the user to select an object or drag an object with the
touch pen or a finger. This is the best mode to use for most applications.
: The “click” is recognized when the screen is touched. To
initiate a new mouse-click, the display must be released and re-pressed.
: Contrary to the click
, it is
a
click when the display is released.
:
: The cursor does not move to the
touch position except at the lift-off point. For a better understanding of this
generated
The first touch point generates a
click. The cursor follows the finger / pen movement.
For a better
understanding of this setting, try it with the
application under the
tab.
Draw Test
Tools
45
To the right of the mouse icon are options to set different mouse-like modes.
Normal mode offers the most intuitive touch-operation.